Cleaning The Hygienic Exhaust Filter - Dirt Devil Infinity V12 Manual De Instrucciones

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 76
02_Infinity_gb.book Seite 34 Donnerstag, 29. Januar 2009 12:56 12
4 Maintenance
4.4 Cleaning the hygienic
exhaust filter
1
a
b
34
The
hygienic
microscopic particles from the exhaust air stream.
Checking: Check the hygienic exhaust filter regularly, at
least every 3 – 6 months.
Cleaning: If during checking you see that the filter is
dirty, clean it as described below:
1. Switch the appliance off and observe the instructions
under
Chapter 3.2, "Switching off and retracting the
power cable".
2. Release the exhaust filter cover by the recessed handle
provided for this purpose (Fig. 24/1) and remove it.
Fig. 24
3. Remove the hygienic exhaust filter by pulling the tab
provided for this purpose (Fig. 25).
4. Clean the hygienic exhaust filter by tapping out the dust
over a dustbin. If this is insufficient, brush the dirt off with
a soft brush, e.g. the furniture brush supplied with the
appliance.
If dry cleaning is insufficient, additionally rinse the filter in
clear, cold water.
ATTENTION:
Fig. 25
The filter is washable, but it may not be cleaned in
dishwashers or washing-machines Also, please do not
use cleansers for cleaning the filters. Leave the filter
element to dry after cleaning (approx. 24 hours at room
temperature). Only re-insert it when it is completely dry.
5. Put the cleaned hygienic exhaust filter back with the tab
pointing up (Fig. 25).
6. Then replace the exhaust filter cover by hooking it in
with the top side first (Fig. 26/a). Lock the cover by
Fig. 26
pressing firmly until you hear and feel it snap into place
(Fig. 26/b).
NOTE:
It might be necessary to push a bit harder.
Make sure when doing this that the cover clicks fully into
place behind both projections provided for this purpose
(Fig. 27). Otherwise the cover and possibly even the
exhaust filter will fall out easily.
Fig. 27
exhaust
filter
(Fig. 23/1)
removes
Tabla de contenido
loading

Este manual también es adecuado para:

M5013-1

Tabla de contenido