Krampouz CGBIC4 Instrucciones De Uso página 23

The burner
Occasionally check the state of the burner outlet holes. If they are blocked, brush the branches with
a hard-bristle brush. Before using again, carefully wipe the burner as well as the bottom of the
combustion chamber.
Be careful:
For models with a safety thermostat from the LUXURY range: the griddle is fixed to the
▪
frame. If you require access to the burner, take care not to damage the probe fixed under the
griddle.
For models with a safety tap from the LUXURY range: unscrew the griddle and lift it up to
▪
access to the burner.
For appliances of the STANDARD range: lift the griddle to access the burner.
▪
Storage
We advise you to store your appliance in a dry and clean place.
Adjusting
Reminder: our appliance adjusting must be made by technicians and installers properly
qualified for gas installations.
If the type of gas supply needs changing it is essential to replace the jets, to reset the air intake to
L=12 mm and to adjust the slow setting.
Refer to datas page 6 and drawings of appliances details page 4.
Replacing the burner jets
If the appliance is already installed, before proceeding with replacement of the burner jets or any
new adjusting, ensure that the gas supply is switched off (whether mains gas or gas cylinder).
Then proceed with the following operations:
1. For appliances of the STANDARD range: remove the griddle and turn the appliance over. For all
the other models, turn the appliance over.
2. Remove the base of the appliance by unscrewing the feet on round appliances with a base
plate, and by removing the screws on square appliances.
3. Open the air inlet as wide as possible by sliding back the ring which regulates air (FIG 4 rep 11).
4. Unscrew the jet (FIG 4 rep. 12) with a 10 mm spanner; take the conversion pack.
5. Change the jet and its washer, following the information given in the reference chart showing
jet diameters and various types of gas supply. (chart page 6).
6. Position the air control ring at the 12 mm position and screw home again.
7. Replace and screw in the base of the appliance. It is advisable to make note of the new
configuration on the manufacturer's rating plate on the base of the appliance and erase the old
one.
8. Put the replaced jet in the conversion pack and keep in a safe place, then turn to the setting up
procedure.
- 23 -