Skil MS6305-00 Manual Del Propietário página 31

Depth-of-cut adjustment
The depth stop limits the downward travel of
the blade when cutting grooves and other non-
through cuts.
To use the depth stop:
1. Unplug the saw.
2. If the saw is in the storage or transport
position, release (pull out) the head-
assembly lock pin and allow the head
assembly to rise fully.
3. Grip the main handle and push the head
assembly down while watching the depth-
of-cut bolt contact the top surface of the
depth-stop (Fig. 32).
4. Loosen the thumbnut and turn the head of the depth-of-cut bolt (while the threaded end
is in contact with the depth stop) and watch the bottom of the saw blade move. This
adjustment sets the depth of cut.
5. Tighten the thumbnut to lock the depth-of-cut bolt in place.
6. See Cutting grooves for additional instructions.
NOTICE: When making normal, full-depth cuts, adjust the depth-of-cut bolt until it does not
touch the depth stop when the head assembly is fully lowered.
Table extensions
Table extensions have been provided for the
left and the right side of the saw.
been installed properly at the factory. They
may be adjusted but may not be removed.
To adjust table extensions:
1. Turn the lock knob counterclockwise
approximately 1/2 turn to loosen
the hex-end of the supplied Double-Ended
Allen Wrench. (Fig.33)
Fig. 32
Fig. 33
They have
Table-extension
it, using
lock knob
Depth-of-
Cut Bolt
Thumbnut
Depth stop
31