Draining Water - Unold 48945 Instrucciones De Uso

appliance reaches the right operating temperature. Therefore, the first ice
cubes are somewhat smaller.
10. When the ice container is full, the „Icefull" indicator light is illuminated
red.
11. The appliance automatically stops making ice cubes.
12. Remove the ice container and empty it. Insert the ice container back into
the appliance.
13. Please note that you must hold the ice container slightly slanted when
inserting it in the appliance.
14. The ice cube maker automatically checks the water level in the water tank.
If the water level is too low, the „Add Water" indicator light is illuminated.
15. The appliance automatically stops making ice cubes. Add water. As soon as
enough water has been added, the process continues automatically.
16. You can interrupt the making of ice cubes any time by pressing the „ON/
OFF" button.
17. When you want to stop making ice cubes, press the „ON/OFF" button and
wait for approx. one minute. Then remove the ice container and empty it.
Drain any remaining water from the appliance as described in the section

„Draining water".

18. Please remember not to leave the ice cubes in the ice container too long,
since they will melt. If you do not wish to use the ice cubes right away, you
can store them in the freezer.
19. After use, please leave the ice cube maker open to prevent the formation of
mould or bacteria.
The water must be changed after 24 hours at the latest, for reasons of
hygiene.
DRAINING WATER
To drain the water from the appliance, please proceed as follows:
Switch off the appliance and unplug it from the electrical outlet.
1. Hold the appliance over a sufficiently large bowl or the kitchen sink.
2. Remove the cap on the residual water drain (5) on the bottom of the
appliance.
26 von 84
Copyright UNOLD AG | www.unold.de
Stand 6.3.2020