General Information; Installation Instructions - Westfalia 104842-00016-16 Instrucciones De Montaje

GB

General information:

The vehicle manufacturer's specifications regarding trailer load and nose weight are deci-
sive for driving, and the values specified for the towing hitch must not be exceeded.
The towed-vehicle assembly may only be used for towing trailers when fitted with a towing hitch or
an automatic bolt coupling and a matching towbar ball receptacle or towbar eye on the trailer. Only
trailers which have been approved may be used with a towing hitch.
Any use other than that specified is prohibited. Driving with a trailer must be adapted to the road
conditions. The vehicle's handling is affected when a trailer is being towed. Follow the vehicle
manufacturer's instructions.
The fixing points specified as standard must be observed.
National guidelines concerning official approval of auxiliaries must be observed.
These installation and operating instructions must be enclosed with the vehicle papers.

Installation instructions:

The towing hitch is a safety component and must only be installed by qualified personnel.
Any alteration or conversion to the towing hitch is prohibited, and would lead to cancellation of
design certification.
Remove insulating compound and underseal from vehicle (if present) in the area of the mat-
ing surfaces of the towing hitch. Seal any bare bodywork and bores with anti-corrosive paint.
Operating instructions:
Again tighten all securing bolts of the towing hitch after approx. 1000 trailer km, observing speci-
fied tightening torques.
The towing hitch must be kept clean and greased. However, if a stabilisation device, e.g.
Westfalia "SSK", is used, the towing hitch must be free from grease. Follow the instructions in
the relevant operating instructions.
As soon as the towing hitch diameter is 49.0 mm or less at any point, it must no longer be used
for safety reasons.
After the towing hitch is fitted, the empty weight of the vehicle increases by 32 kg.
26