Hitachi Koki CR 18DL Manual De Instrucciones página 24

English
CAUTION: Delay the feed speed when cutting
5. Plunge cutting
With this tool, you can perform pocket cutting on
plywood panels and thin board materials. You can
carry out pocket cutting quite easily with the saw blade
installed in reverse as illustrated in Fig. 28, Fig. 30,
and Fig. 32. Use the saw blade that is as short and
thick as possible. We recommend for this purpose that
you use BI-METAL Blade No. 132 mentioned in Page
29. Be sure to use caution during the cutting operation
and observe the following procedures.
(1) Press the lower part (or the upper part) of the
base against the material. Pull the switch trigger
while keeping the tip of the saw blade apart from
the material. (Fig. 27, Fig. 28)
(2) Raise the handle slowly and cut in with the saw
blade little by little. (Fig. 29, Fig. 30)
(3) Hold the body firmly until the saw blade
completely cuts into the material. (Fig. 31, Fig. 32)
CAUTION:
Avoid plunge cutting for metallic materials. This
can easily damage the blade.
Never pull the switch trigger while the tip of
the saw blade is pressed against the material.
If you do so, the blade can easily be damaged
when it collides with the material.
Make absolutely sure that you cut slowly while
holding the body firmly. If you apply any
unreasonable force to the saw blade during the
cutting operation, the blade can easily be
damaged.
24
the material into small circular arcs.
An unreasonably fast feed may break
the blade.
Fig. 30
Fig. 31
Fig. 32