Notes For Personnel; Safety Instructions For Working With Electrical Equipment - zarges ZAP Serie Instrucciones De Montaje Y De Uso

2.4 Notes for Persons under the influence of drugs, alcohol or medication reducing reaction
personnel times must not be allowed to handle or work on or with the product.
2.5 Safety The following safety instructions must be observed when:
instructions for
• working with electrical equipment on the product
working with
• using the product in the vicinity of electrical units
electrical
• using the product in the vicinity of overhead power lines
equipment
D
D
Electrical equipment may only be used on the product:
D
D
The product may only be used in the vicinity of such units if the following conditions
are met:
D
D
When working near overhead power lines, observe the safety clearances listed in
the following table:
> For outdoor use, ballasting is required for the product with Item No. 41328
starting from a platform height of 2.65 m. This is done by attaching a ballast
weight, Item No. 41331, to each stabiliser.
> Check the subsurface for a possible risk of slipping caused by moisture, ice,
snow or soiling.
> Always wear appropriate protective clothing when working on and with the
product (protective gloves, safety shoes).
> Never leave the product unattended in places accessible to the public. Secure
the product against unauthorised access.
> Do not throw materials or tools, but pass them up or down from person to
person.
> Check the equipment for correct functioning before each use. Do not use the
product if parts are missing or damaged.
ANGER
ANGER OF ELECTRIC SHOCKS WHEN USING ELECTRICAL EQUIPMENT ON THE PRODUCT
> with Safety Extra Low Voltage (48 V)
> with protective insulation (separation transformer)
> if the equipment is connected via a ground fault circuit interrupter with a
residual current of max. 30 mA
ANGER
ANGER OF ELECTRIC SHOCKS WHEN WORKING IN THE VICINITY OF CURRENT
> The unit must be disconnected and secured against being switched back on.
> The section of the unit in question must be de-energised.
> The section of the unit must be earthed by means of an earthing strap.
> The section of the unit must be insulated against any adjacent current-bearing
components.
ANGER
ANGER OF ELECTRIC SHOCKS WHEN WORKING IN THE VICINITY OF OVERHEAD POWER LINES
Rated voltage (V)
< 1000 V
1 kV – 110 kV
110 kV – 220 kV
-
BEARING UNITS
Safety clearance (m)
1.0 m
3.0 m
4.0 m
!
!
!
17