Connecting The Bru-Sf10 Optical Multiplex Unit - Sony RM-IP10 Manual De Instrucciones

Connecting the BRU-SF10 Optical
Multiplex Unit
You can control the camera using this unit via the BRU-
SF10 Optical Multiplex Unit (not supplied).
IN VISCA RS-232 OUT
BRBK-SF1 HD Optical
Multiplex Card
CAMERA
RGB/COMPONENT
connecting cable
to RGB/
with D-sub 15-pin
component
input
(commercially
HD monitor, etc.
MODE
16
GB
Connections
HD camera
BRC-H900
1 2 3
1 2 3 4 5 6 7 8 9
IR SELECT
VISCA RS-422 OFF ON HD SD
RGB/COMPONENT
75
DC IN 12V
EXT SYNC IN VIDEO S VIDEO SDI OUT
to the AC adaptor
Optical connector
CCFC-S200 Optical
Fiber Cable
BRU-SF10
IN OUT IN OUT
1 2 3 4 5 6 7 8 9
HD Optical
CAMERA EXT SYNC RGB/COMPONENT VISCA RS232C
VISCA RS422
L AUDIO OUT
Multiplex Unit
FUNCTION
R 1
10
DC IN 12V
to AC outlet
VISCA RS-232C IN
connectors
available)
RS-232C cable
(supplied with the
BRU-SF10)*
VISCA RS-232C
!
LAN RS-232C RS-422 TALLY/CONTACT
VISCA
1 9 1 9
DC 12V
AC power
cord
(supplied)
AC power adaptor
MPA-AC1 (supplied)
* The VISCA RS-422 connection is also available if you use the
VISCA RS-422 connectors.
For other cameras, you can also use a matching Optical
Multiplex Unit to control the camera with this unit. For
details on connection, refer to the Operating Instructions
supplied with your camera.
Notes
• When using the VISCA RS-232C connectors or
VISCA RS-422 connectors, check the VISCA
FUNCTION switch on the rear of the Optical
Multiplex Unit and the DIP switch on the bottom of
this unit (page 9) are set correctly.
• The BRU-SF10 and BRU-H700 Optical Multiplex
Units are not compatible with the IP connection. Use
them for the RS-232C or RS-422 connection only.
to AC
outlet