Char-Broil Patio Bistro 240 Instrucciones De Funcionamiento página 3

Safety Tips
Before opening gas cylinder valve, check the regulator for
Ÿ
tightness.
When appliance is not in use, turn off all control knobs and
Ÿ
gas.
Use long-handled barbecue utensils and oven mitts to
Ÿ
avoid burns and splatters. Use protective gloves when
handling hot components.
The grease cup (if equipped) must be inserted into
Ÿ
appliance and emptied after each use. Do not remove
grease cup until appliance has completely cooled.
Be very careful when you open the lid, since hot steam
Ÿ
may escape.
Be very careful when children, the elderly, or pets are
Ÿ
nearby.
If you notice grease or other hot material dripping from
Ÿ
appliance onto valve, hose or regulator, turn off gas supply
at once. Determine the cause, correct it, then clean and
inspect valve, hose, and regulator before continuing.
Perform a leak test.
Keep ventilation openings in cylinder enclosure (appliance
Ÿ
cart) free and free of debris.
Do not store objects or materials inside the appliance cart
Ÿ
enclosure that would block the flow of combustion air to the
underside of either the control panel or the firebox bowl.
DO NOT disconnect or change gas container within 3m of
Ÿ
an open flame or other ignition source.
Cylinder Placement
All cylinder are to be placed on the ground beside the appliance.
DO NOT PLACE CYLINDERS ON BOTTOM SHELF. Maximum
cylinder diameter 320 mm and height 600 mm.
Regulator Requirements
A regulator must be used with this appliance. Use only gas
regulator supplied with your barbeque. If a regulator is not
supplied then use only regulator certified according to
EN12864 or EN16129 (Flow rate max. 1.5 kg/h) and approved
for your country and gas specified in Technical Data.
Hose Requirements
Use only approved hose which is certified to appropriate EN
standard and does not exceed 1.5m length. For Finland, the
hose length shall not exceed 1.2m.
Before each use, check to see if hoses are cut or worn. Make
sure hose is not kinked. Make sure that when connected hose
does not touch any warm surfaces. Replace damaged hoses
before using appliance. Replace hose as required by national
requirements.
Ignitor Lighting
READ INSTRUCTIONS BEFORE LIGHTING.
Do NOT lean over appliance while lighting.
1. Turn gas burner control valve to
2. Turn ON gas cylinder.
3. Open the appliance lid.
4. Press and turn the control knob to the Ignition
5. Push and hold ELECTRONIC IGNITOR button until the
burner lights.
6. Once the burner has ignited, turn the control knob to the
desired setting.
7. If ignition does not occur in 5 seconds, turn the burner
control knob , wait 5 minutes, and repeat lighting
procedure.
If ignition still does not occur, follow match-lighting
WARNING
Turn control knob and gas cylinder OFF when not in use.
Match-Lighting
Do NOT lean over appliance while lighting.
1. Turn gas burner control valve to
2. Turn ON gas at cylinder.
3. Open appliance lid.
4. Insert match into match holder. Strike match. Place lit match
into match light hole at the rear of the appliance bottom,
shown "A". Make sure lit match is placed inside through the
hole and near burner.
5. Push in and turn control knob to position 5 . Be sure
burner lights and stays lit.
A
Rotate Match
Light Hole
Cover
3
.
position.
instructions.
.
Match Light
Hole
View is from
rear of
appliance