Preset Modes; Selecting The Input Signal - Sony GDM-W900 Manual De Instrucciones

Preset Modes

Preset modes
The monitor has nine factory preset modes for true "Plug &
Play" capability.
Table of preset modes
No. Resolution Horizontal Vertical
(dots×lines) Frequency Frequency
640 × 480
1 31.5 kHz
720 × 400
2 31.5 kHz
1280 × 1024
3 80.0 kHz
1600 × 1200
4 93.8 kHz
1920 × 1080
5 67.5 kHz
1920 × 1080
6 84.4 kHz
1600 × 1024
7 81.3 kHz
1920 × 1200
8 95.0 kHz
1920 × 1035
9 33.8 kHz
1) VESA is a trademark of Video Electronics Standard Association.

Selecting the Input Signal

This monitor has two signal input connectors and can
connect two computers. When the power of both computers
is on, select the signal you want to input as follows.
1
Turn on power of the monitor and the computer.
2
Select the input signal.
HD15 BNC
AUTO
INPUT
To input the signal from the computer connected to
the 5 BNC's connector
Set the INPUT switch to BNC.
To input the signal from the computer connected to
the HD15 connector
Set the INPUT switch to HD15.
If only one computer is connected or turned on
Set the INPUT switch to AUTO (center position). The
input signal is automatically selected.
Graphic mode
60 Hz VGA Graphic
70 Hz VGA Text
75 Hz VESA 1)
75 Hz VESA
60 Hz Sony
72 Hz Sony
76 Hz Sony
76 Hz Sony
60 Hz HDTV
User modes
When using a video mode that is not one of the preset
modes, some fine tuning may be required to optimize the
display to your preference. Simply adjust the monitor
according to the adjustments instructions on pages 9 to 15.
The adjustments will be stored automatically and recalled
whenever that mode is used.
A total of 16 user-defined modes can be stored in memory.
If a 17th mode is entered, it will replace the first.
For less common modes, and modes that may evolve in the
future, the Digital Multiscan Technology of this monitor will
perform all of the complex adjustments necessary to ensure
a high quality picture for any timing in its frequency range.
However, due to the wide variety of video boards on the
market, it may be necessary for the user to fine tune the
vertical/horizontal size and centering.
Recommended horizontal timing conditions
Horizontal sync width should be more than 0.8 µsec.
Horizontal blanking width should be more than 2.7 µsec.
® 2)
Note for Windows users
Check your video board manual or the utility program
which comes with your graphic board and select the highest
available refresh rate to maximize monitor performance.
2) Windows is a registered trademark of Microsoft Corporation in
the United States and other countries.
3
If necessary, adjust the user controls according to
your preference on pages 9 to 15.
When you set the INPUT switch to "AUTO"and
connect computers to both connectors
If you turn on or restart the computer you want to input a signal
from, or the computer is in power saving mode, the monitor may
automatically select another computer's signal. This is because no
signal is input to the monitor at that moment. If this happens,
select the signal using the INPUT switch.
For the customers using the Windows95
Even if you select SONY for the maker on the device select screen,
the model name (GDM-W900) may not appear. In this case, select
the DDC standard monitor.
EN
F
D
ES
I
J
5