Choice And Use Of Brushes - COMAC OMNIA 26 Manual De Uso

Ocultar thumbs Ver también para OMNIA 26:

Manual de uso (28 páginas)

100

101

102

103

104

105

106

107

108

109

110

111

112

113

114

115

116

117

118

119

120

121

122

123

124

Tabla de contenido

Idiomas disponibles

POLYPROPYLENE BRUSH (PPL)

It is used on all types of floors, which are hot water resistant (not more than 60 ° C). The Polypropylene brush is nonhygroscopic

and therefore conserves its characteristics even if working in the wet conditions.

NYLON BRUSH

It is used on all types of floors with excellent wear and hot water resistance (more than 60 ° C). The nylon is hygroscopic and so,

over time, looses its characteristics working on the wet.

ABRASIVE BRUSH

The brush bristles are charged with very aggressive abrasives. It is used to clean very dirty floors. To avoid floor damages, work

strictly only with the necessary pressure.

STEEL BRUSH

The bristles are made of steel wires or flat blades or can be mixed, by means of steel and synthetic fibres. The steel wire brush is

used to descale very uneven floors or with wide joints. The brush with steel blades is used to scrape off more resistant

incrustations.

THICKNESS OF THE BRISTLES

The thicker the bristles are, the more rigid they will be. These ones are therefore used on smooth floors or with small joints.

On uneven floors with deep joints it is recommended that, softer bristles, which enter more easily in depth, are used.

Please bear in mind that, when the bristles are worn out and get too short, they will get rigid and cannot penetrate anymore. As

well as for thick bristles, the brush will begin to jump.

PAD HOLDER

The pad holder is recommended to clean glossy areas.

There are two types of pad holders:

1. The traditional pad holder is equipped with anchor points, which allow the abrasive pad to be held and dragged during the

work process.

2. The pad holder is of the CENTER LOCK type, apart from the anchor points, is equipped with a central blocking release system

made in plastic. This allows a perfect match with the abrasive pad and to hold it without the risk of falling down. This type of

pad holder is recommended especially for machines with more brushes, where the centering of the pads is difficult.

LIST FOR THE CHOICE OF THE BRUSHES

Machine

Q.ty

OMNIA26

OMNIA32

OMNIA42