How To Transport The Machine; At The End Of Work - COMAC cm mini orbital Manual De Uso Y Mantenimiento

HOW TO TRANSPORT THE MACHINE

To transport the machine, proceed as follows:
1. Adjust the height of the handle by opening and closing the lever (1) on it as shown (Fig.1)
2. Check that the machine is disconnected from the power socket (1) (Fig.2), check that the hook 2 is
anchored in place (Fig.3).
3. Tilt the machine until the wheels touch the floor.
4. If you want to lift the machine, grab the front handle 1 and the handle 2 (Fig.4).
WARNING: It is advisable to always wear protective gloves to avoid serious injury to your hands.
ATTENTION: To avoid damaging the power cord, disconnect the plug from the socket by pulling
the plug directly instead of the cord.
1
1
1
3
LOCATION OF COMPONENTS
I componenti basilari dell'apparecchio s'identificano come
segue:
1. Handle
2. Handlebar handle
3. Base handle
4. Handlebar handle
5. Power cable
6. Power button
7. Basement
8. Driving plate
2
1
4
3
7
2
2
9. Carter cover
10. Wheels for transport
11. Handle joint
11
10
Before starting to work you need to do the following:
1. Before use, the regular condition and safety of the appliance must be checked with work equipment,
especially the power cord and extension cord. If the status is not perfect, the use of the appliance
is prohibited.
2. Insert the plug (1) of the power cable into the socket (2) of the power supply (Fig.1).
3. Release the handle acting on the pin (1), with your foot or with your hand on push the hook upwards
(Fig.2).
4. Then start the machine by pressing the power button (1) (Fig.3).
ATTENTION: Do not rest your foot on the appliance during this operation.
1
1
3
At the end of the work and before any type of maintenance perform the following operations:
1. After turning off the machine, disconnect the plug (1) from the socket (2) of the power supply (Fig.1).
WARNING: These operations must be performed using gloves to protect yourself from possible
contact with the edges or tips of metal objects.
ATTENTION: To avoid damaging the power cord, disconnect the plug from the socket by pulling
the plug directly instead of the cord.
1
6
5
9
8
17
WORK
3
1
1
2
1

AT THE END OF WORK

2
1