Technical Specifications; Environmental Protection - Metabo BST 9.6 Instrucciones De Manejo

8090.book Seite 12 Donnerstag, 23. Mai 2002 2:49 14
ENGLISH
ENG
9 Accessories
Use original Metabo accessories only.
To assist in selecting the correct accessories,
make sure that you take a note of the exact
model of your tool for your dealer.
A ICS 10 Superfast Charger
B IC 25 Charger
C C 60 Charger
D Holster
E Battery packs of varying capacities
Buy only battery packs of the correct
voltage for your cordless tool.
10 Repairs
Repairs to power tools must be
carried out by a qualified electrician
only.
Any Metabo power tool in need of repair can be
sent to one of the addresses listed in the spare
parts list.
Please attach a description of the fault to the
tool.

11 Environmental Protection

Metabo packaging is 100% suitable for recy-
cling.
Power tools and accessories at the end of their
service life still contain large amounts of valu-
able raw materials and plastics which can like-
wise be fed back into a recycling process.
These Operating Instructions are printed on
paper produced in a chlorine-free bleaching
process.
Battery packs must not be disposed of along
with domestic waste.
Return any faulty or exhausted battery packs to
your Metabo dealer.
Do not throw battery packs away in water.
12

12 Technical Specifications

Notes on the information printed on page 2.
We reserve the right to undertake modifica-
tions to reflect technical advances.
U = battery-pack voltage
n = no-load speed
Tightening torque when driving screws:
M = driving into soft materials (wood)
1
M = impulse torque
2
M = driving into hard materials (metal)
3
M = adjustable tightening torque
4
Max. bit diameters:
D = into steel
1 max
D = into soft wood
2 max
D = into concrete
3 max
m = weight (with smallest battery pack)
G = spindle thread
D = chuck capacity
Typically A-rated acoustic levels:
L = acoustic pressure level
pA
L = acoustic power level
WA
During operation, the acoustic level may
exceed 85 dB(A).
Wear ear protectors!
a = typically rated acceleration in the
hw
hand/arm area.
s = max. impacts per minute
Measured values established according to
EN 50144.
The stated technical specifications are subject
to tolerances (according to the applicable valid
standards).