GE RGS1540Z Manual De Uso página 47

LeveLLinG
To level the refrigerator use the two
levelling screws found on the base at
the front.
Make sure that the refrigerator is placed
on level ground. adjust the levelling
screws to ensure that the refrigerator
doesn't move during day-to-day use.
Turn the screws anti-clockwise to lift the
front of the refrigerator and clockwise
to lower it.
The front part of the refrigerator should
be a little higher than the back causing
it to tilt backwards slightly. Levelling
requires two people; one to tilt the unit
backwards and the other to turn the
screws.
To level it, lift the front by turning the
screws until there is a 48 mm (1.9 in)
gap between the floor and the base of
the refrigerator, as indicated in the figure
on the right.
oBSeRve THe FoLLoWinG WHen inSTaLLinG:
iMPortant– after leaving the refrigerator to stand 6 to 8 hours:
and before plugging it in:
1. Clean the interior of your refrigerator with a cloth or soft sponge, and a
neutral soap or a bicarbonate of soda solution.
2. Plug it in to the correct outlet.
3. Leave it on, empty and closed, for 4 hours before putting food inside.
4. avoid opening the door before optimum temperature has been
reached.
5. if you want to move your refrigerator to another location, disconnect it.
When it has been repositioned repeat steps 3 and 4.
CaUtion
in the case of physical, mental or sensorial difficulties
(including children), or if you don't have sufficient experience or
knowledge to handle this product, you will need the assistance
of a capable adult to ensure safety.
Children should always be supervised. This product is not
a toy.
Front
Levelling Front
screws wheels
Front
Front
Levelling Front
screws wheels
Back
wheels
Back
wheels
47