9- OPERATING INSTRUCTIONS
In order to set the unit to connect automatically:
Note!
The automatic connection can only be made with the unit switched off.
Press the OFF button.
Press the TIMER button.
The timer settings range from 1 to 24 hours. Each time the TIMER buttion is pressed the sequence will be as
follows: 1 - 2 - ... up to 24 and cancel (no indication). If you continue pressing it starts counting all over again
The selected time will be shown on the remote controller display. During the countdown process the
display will always show the remaining time.
In order to cancel the TIMER mode:
Press the TIMER button until 24 appears on display. Press the TIMER button once more to cancel this mode.
Note!
Restart the time configuration after replacing the batteries or after a possible power failure.
9.12 EMERGENCY OPERATION KEY
This key can be used as an emergency measure to connect/disconnect the unit in case the remote
controller is not available.
Fig. 7.8 Emergency operation/operation test key.
Legend
1- Emergency operation key
Warning!
Do not open the grid at an angle of more than 60º.
Do not force the unit with too much strength.
11