Tabla de contenido
Troubleshooting hints
Cosa fare in caso di anomalie
En caso de problemas
establish whether REAR mode is possible with the
given camera, and how to proceed.
TTL (E-TTL) high-speed synchronisation (HSS) can-
not be set on the mecablitz.
TTL (E-TTL) high-speed synchronisation (HSS) is current-
ly only possible with the mecablitz 54 MZ-3!
• TTL (E-TTL) high-speed synchronisation (HSS) can only
be set on the mecablitz if the latter is fitted with a sui-
table SCA 3xx2 adapter (see SCA Adapter Operating
Instructions) and is mounted on the switched-on
camera. Data exchange between camera and SCA
adapter must have taken place at least once (simply
tap the camera's release button lightly without tripping
the shutter). The camera must be able to support TTL
(E-TTL) high-speed synchronisation in the selected
flash mode (Manual M or TTL) (see Camera and SCA
Adapter Operating Instructions)!
• TTL (E-TTL) high-speed synchronisation (HSS) cannot
be combined with the Metz cordless remote flash
system.
• Depending upon the given camera system, TTL (E-TTL)
high-speed synchronisa-tion (HSS) can be activated on
the mecablitz 54 MZ-3 in the M manual flash mode
(Ca, Mi, Ni) or in the TTL mode (Ca, Mi)!
• NOTE: To activate TTL (E-TTL) high-speed synchronisa-
tion (HSS) ensure that the secondary reflector of the
mecablitz is not switched on!
• (Mi): TTL (E-TTL) high-speed synchronisation (HSS) is
not possible when the main reflector is swivelled or til-
ted. The shutter speed is limited to the camera's flash
synch speed. The display (H) for TTL (E-TTL) high-
speed synchronisation (HSS) is extinguished in the
camera's viewfinder!
(Ni): The 3D mode cannot be set on the mecablitz
when in TTL mode.
• REAR mode has been set on the mecablitz and "REAR"
is indicated on the display.
Remedy: First switch on REAR mode and then 3D
mode.
• The mecablitz must be fitted with the SCA 3402 adap-
ter. The 3D TTL mode can only be set on the mecablitz
if it is mounted on a switched-on camera that supports
the 3D mode. Data exchange between camera and
SCA adapter must have taken place at least once (sim-
ply tap the camera release lightly without tripping the
shutter).
• The 3D TTL mode is not supported if the mecablitz is
102
Tabla de contenido
