Bobbin Winding - Sears Kenmore 385.18330 Manual De Instrucciones

• Bobbin winding
(_) For horizontal spool pin
(_ For additional spool pin
[] Pull the handwheel out to the right,
[] Draw thread from the spool.
[] Guide the thread around the thread guide.
[] Thread through the hole in the bobbin from the inside to
the outside.
[] Put the bobbin on the bobbin winder spindle,
[] Push the bobbin to the dght,
[] With free end of the thread held in your hand, depress the
foot control. Stop the machine when it has made a few
turns and cut the thread close to the hole in the bobbin°
[] Depress the foot control again. When the bobbin is fully
wound, it stops automatically. Return the bobbin winder
to its original position by moving the spindle to the left and
cut the thread as shown.
[] Push the handwheel in.
* The machine does not function until the clutch is engaged,,
NOTE:
Position of the bobbin winder stopper is adjustable
for the required amount of thread on the bobbin
(example 1/2 full or full etco).
Use a screwdriver and loosen the screw one turn or
tess so that you can adjust the position of the bobbin
winder stopper,
Do not take o_ the screw atl the way.
l_
r
%D
[]
[]
..... J
_J
J
22