Tabla de contenido
Idiomas disponibles
Idiomas disponibles
User Manual
9.3.- Time
The Receiver has a clock that shows the time. This clock is automatically
adjusted with the information received from the service supplier within the
satellite signal itself. Nevertheless, both date and time can be set without
using the GMT option.
The service supplier sends two kinds of time information, one with the
current time (for viewing on the clock), and the other informing the broad-
casting times of the different events (to be used in the EPG).
Both kinds of time information are sent in the GMT format, so you should
adjust the Receiver by entering your country's time-zone offset in this
option.
Select the "Time" option on the menu "Time and Timer setting", and
press the OK button.
Enable the option "GMT usage" (On).
Using the V+/V- buttons, indicate whether you want to increase (+) or
reduce (-) GMT time by 30-minute periods to correspond with local time.
If you wish to set time independently of the GMT option, you must
disable this option to allow you to edit the date and time.
With the option "Time Display" enabled, current updated time is shown
permanently on screen.
Press the EXIT button to leave the menu and save the data.
NOTE: Not all of the suppliers provide this type of information
9.4.- Timer
The receiver has a timer to turn it on and off automatically at given times. It
has 8 positions for programming the same number of events. You only have
to enter the following data.
By default, the cursor will appear always on the first free timer number. If
no event has been programmed, it will be on number 1.
- Timer Number.- Select one of the 8 available events using the V+/V-
buttons.
- Timer Mode.- By default, it will appear in the "Off" mode. You can select
other modes, such as: "Once", "Daily" (once a day), "Weekly" (once a
week), "Monthly" (once a month), or "Yearly" (once a year). The selection is
made by pressing the V+/V- buttons.
52
"RSD - 7118"
Capítulos
Tabla de contenido
