Panasonic EY6903 Manual De Instrucciones página 8

. ACCESSORIES
Use only bits suitable for size of drill's chuck.
. APPENDIX
RECOMMENDED SPEED SELECTION
CAUTION:
USE AT LOW SPEED WHEN STRONG FORCE IS NEEDED DURING OPERATION.
(Using at high speed while a strong force is applied may cause a motor breakdown.)
Use the following as a guide to select low or high speed for the job.
EY6903
MATERIAL/ MORTAR /
CONDITION BRICK
HIGH ø 10 mm (3/8") or less Not used
ø 10 mm (3/8") or less
LOW
(Slow operation)
EY6932
MATERIAL/
MORTAR / BRICK
CONDITION
HIGH ø 10 mm (3/8") or less Not used
ø 13 mm (1/2") or less
LOW
(Slow operation)
DRILLING
WOOD /
METAL
YELLOW PINE
Thickness: 40 mm Cold-rolled steel plate (SPC)
(1-37/64") or less Thickness: 1.6 mm (1/16") or less
ø 4.5 mm (11/64")
or less
ø 25 mm (63/64") ø 13 mm (1/2")
or less or less
DRILLING
WOOD /
METAL
YELLOW PINE
Thickness: 40 mm Cold-rolled steel plate (SPC)
(1-37/64") or less Thickness: 1.6 mm (1/16") or less
ø 6.5 mm (1/4")
or less
ø 36 mm (1-27/64") ø 13 mm (1/2")
or less or less
- 8 -
SCREW
TIGHTENING
METAL HOLE SAW
Wood screws
ø 3.5 mm (9/64")
Not used
or less
ø 26 mm ø 6 mm (15/64")
(1-1/64") or less or less
SCREW
TIGHTENING
METAL HOLE SAW
Wood screws
ø 4 mm (5/32")
Not used
or less
ø 34 mm (1-11/32") ø 6.8 mm (17/64")
or less or less