Panasonic RP-BTGS10 Instrucciones De Funcionamiento página 15

CAUTION
THE FOLLOWING APPLIES IN THE U.S.A. AND CANADA
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference, and
(2) this device must accept any interference, including interference that
may cause undesired operation of this device.
FCC ID : ACJ-RP-BTGS10
IC : 216A-RPBTGS10
This transmitter must not be co-located or operated in conjunction with
any other antenna or transmitter. This equipment complies with FCC/IC radiation exposure limits set forth for an
uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines
in Supplement C to OET65 and RSS-102 of the IC radio frequency (RF) Exposure rules.
This equipment has very low levels of RF energy that are deemed to
comply without testing of specific absorption ratio (SAR).
THE FOLLOWING APPLIES ONLY IN THE U.S.A.
FCC Note:
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
• Consult the dealer or an experienced radio/TV technician for help.
Any unauthorized changes or modifications to this equipment would void
the user's authority to operate this device.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Responsible Party: Panasonic Corporation of North America
Support Contact: http://www.panasonic.com/contactinfo
THE FOLLOWING APPLIES ONLY IN CANADA.
CAN ICES-3(B)/NMB-3(B)
VQT5C48_RP-BTGS10_PP_En.indb 15 VQT5C48_RP-BTGS10_PP_En.indb 15
• Danger of explosion if battery is incorrectly replaced. Replace only with
the type recommended by the manufacturer.
• When disposing of the batteries, please contact your local authorities
or dealer and ask for the correct method of disposal.
which the receiver is connected.
Two Riverfront Plaza, Newark, NJ 07102-5490
15
15
2013/11/29 19:47:24 2013/11/29 19:47:24