Setting The Time; Alarm Time Setting - Medisana Medibreeze PLUS Instrucciones De Manejo

Humidificador intensivo com temporizador
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 37

Setting the time

(CLOCK)
Alarm time
setting
3.8
Timer start/clear
function
Notes on setting the timer.
If the idle period ("TIMER", "OFF") is set to 0:00, the device automatically switches
itself off after the first operating period. If the idle period has been set to a certain
time (e.g. 4:15), when it is switched on the device alternates between the operating
and idle periods until the water in the water tank has been used up. In the example
that is shown, the device switches on at 20:30 and operates for 2 hours and 30
minutes. Then it switches off again for 4 hours and 15 minutes. It then starts to
operate again for 2 hours and 30 minutes etc.
• "CLOCK" appears in the display
activate the alarm function. In this case the alarm bell symbol appears. Press the
ENTER button
. The time can now be set.
• The hours begin to flash. Press the SET button
hour value is displayed and confirm by pressing the ENTER button
minutes now start to flash.
• Press the SET button
and confirm by pressing the ENTER key
• "24" appears in the display
hour display format by pressing the SET button
to confirm your selection. The time is stored.
• Now set the required alarm time. "ALARM" appears in the display
hours for the alarm time by pressing the SET button
the setting by pressing the ENTER button
• Press the SET button
played and confirm again by pressing the ENTER key
Notes on setting procedure
If you just wish to change the time or the alarm time later, hold down the MODE
button
for 3 seconds to start the setting mode. Pressing the MODE button
again takes you straight to the time entry, and pressing again it takes you to alarm
time entry.
• To start the timer function, press the
itself on and displays the remaining operating time in the display
the operating time has elapsed, your Medibreeze PLUS automatically swit-
ches itself off for the duration of the idle period and then starts the timer cycle
again.
Note on timer function:
When the water in the water tank has been used up the device switches itself off.
Once the time function has been programmed it is retains its settings, even if
the device is switched off. When the device is switched on again the timer function
restarts.
If you wish the device to operate continuously again, the two timer intervals
must be cleared. To do this, set the timer intervals ("ON" and "OFF") to 0:00.
Alternatively you can unplug the device and remove the batteries from the battery
compartment beneath the device. Replace the batteries after several seconds
.
. Press the SET button
repeatedly until the current minute value is displayed
.
to indicate that you can select 12-hour or 24-
. The minutes now begin to flash.
repeatedly until the required minute value is are dis-
button
3 Operating
if you wish to
repeatedly until the current
. The
. Press the ENTER button
. Set the
repeatedly. Confirm
. The setting is complete.
. The humidifier switches
. When
GB
13
Tabla de contenido
loading

Este manual también es adecuado para:

60001

Tabla de contenido