Operating Time - Medisana AH 665 Instrucciones De Manejo

60068_AH665_6spr_07012015.qxd:Luftbefeuchter
2. ON/OFF: ON/OFF: Use this button to switch the device on and off. Pressing the ON/OFF button once
activates the display, the device operates at the lowest mist output. At the same time the fan motor
starts to operate. Pressing the ON/OFF button again switches off all functions and the display goes out.
3. PRESET: This button enables you to select a period after which the device automatically activates.
Press this button when the device is in stand-by mode. A period of time between 1 and 24 hours can
be preset. The selected time is shown in the control panel display
preset time period has counted down to zero, the device starts to operate. The starting time (preset)
can be combined with the timer.
4. MIST: Four different output levels can be set for the mist output from low, middle, strong to highest.
The corresponding outputs are 13-16 W (L), 17-20 W (M), 21-24 W (S) to 25-30 W (H). The selected
output level is shown in display
5. TIMER: This button enables you to select a period after which the device automatically switches off.
A period of time between 1 and 24 hours can be preset. 0 means that all presets are deleted. 3
seconds after entering your preset, the time period starts counting down. The elapsing time is
displayed in minute increments with the current humidity level at intervals of 5 seconds if a humidity
level (humidistat) has been set. The time can be combined with the start time (preset).
6. HUMIDISTAT: This button can be used to set a required level of relative humidity in a room in 5%
increments from 40 to 95%. 0 means that all presets are deleted. 3 seconds after entering your
present, the humidity controller starts to operate. It stops operating as soon as the current air
humidity exceeds the preset value. The fan motor runs for another 5 minutes. As soon as the current
air humidity drops to 2% below the preset value, the humidity controller starts operating again. The
current humidity level is shown in the display, at intervals of 5 seconds alternating with the elapsing
time, if a setting has been made using the timer.
7. ANION: Press the ANION button if the device is in stand-by mode and presets have been made for
the humidity controller. The air purifier function (ionisation) switches on. At the same time the fan
motor starts to operate. Press the ANION button again to switch off the air purifier function. The fan
motor continues to run all the time the humidity controller is active.
8. Protection against empty tank: As soon as the tank runs empty, the display flashes waterless ("tank
is empty"). The device switches off automatically. The timer and humidistat (humidity controller)
settings are also deleted. Once the device has been refilled with water, the function settings can be
entered again.
3.4 Faults and Fault Remedying
• Device will not switch on (LED not illuminating): Plug in the plug; Check power circuit, socket and fuse.
• No mist (LED lights up red): Fill water tank.
• No mist although tank full: Increasing mist intensity; Place device on a level surface; Clean atomiser and
generator using provided brush and fill tank with clean water; Rinse device with clean water.
• White deposits: Use clean water or at least 1/2 distilled water / 1/2 fresh tap water. If a fault cannot
be remedied using the described method, please contact your service centre.

3.5 Operating time

Operation time is approx. 15 hours at the maximum setting (300 ml/h) with 4500 ml of water.
07.01.2015
as an illuminated graphic.
7:35 Uhr Seite 29
3 Operating
in minute increments. Once the
GB
29