Fitting The Battery; Fitting The Side Handle; Working With The Power Tool - Hilti AG 125-A22 Manual De Instrucciones

is indicated by the LED display (see charger operating
instructions).

6.3 Fitting the battery

CAUTION
Check that the power tool is switched off and the
switch interlock activated before fitting the battery.
Use only the Hilti batteries approved for use with this
power tool.
CAUTION
Check that the terminals on the battery and in the
power tool are free from foreign objects before in-
serting the battery in the power tool.
1. Push the battery into the power tool from the rear as
far as it will go and until it is heard to engage with a
double click.
2. CAUTION If it is not fitted securely, the battery
could fall out while you are working with the tool.
CAUTION A falling battery may present a risk of
injury to yourself or others.
Before beginning the work, check that the battery is
fitted securely to the tool.
6.4 Removing the battery from the power tool
1. Press both battery release buttons.
2. Pull the battery out of the power tool toward the
rear.
6.5 Transport and storage of battery packs
Pull the battery pack out of the locked position (working
position) and move it into the first click-stop position
(transport position).
If you disconnect a battery pack from the power tool
for transport or storage, make sure that the contacts of
the battery pack are not short-circuited. Remove loose
metal parts such as screws, nails, clamps, loose screw
bits, wires or metal swarf from the case, toolbox or
transport container, or prevent these parts from coming
into contact with the battery packs.
Observe national and international transport regulations
when shipping battery packs (transportation by road, rail,
sea or air).

6.6 Fitting the side handle

WARNING
The side handle must be fitted for all types of work.
The side handle may be screwed onto the tool on the
right or left.

6.7 Working with the power tool

Take care to ensure that the closed side of the guard is
always positioned toward the operator's body. Adjust the position of the guard to suit the requirements
of the work being done.
6.7.1 Fitting the guard 5
NOTE
The guard is equipped with locating lugs that ensure only
guards of a type suitable for use with the power tool can
be fitted. The locating lugs of the guard fit into the guard
mount on the power tool.
1. Pull the battery out of the power tool.
2. Fit the guard onto the drive spindle collar so that the
two triangular marks on the guard and on the power
tool are in alignment.
3. Push the guard onto the drive spindle collar; press
the guard release button.
4. Rotate the guard until it engages and the guard
release button jumps back into its original position.
6.7.1.1 Adjusting the guard
1. Pull the battery out of the tool.
2. Press the guard release button and then rotate the
guard until it engages in the desired position.
6.7.2 Fitting the cutting and grinding guards
NOTE
Read the instructions for fitting the corresponding guard.
NOTE
If you use the front cover, fit it by pushing it onto the
guard.
6.7.2.1 Fitting the cutting guard 4 6
NOTE
Take care to ensure that the on / off switch is freely
accessible and operable at all times.
6.8 Fitting the cutting / grinding disc 7 9
WARNING
If the nut securing the disc and flange is not tightened
firmly, the disc may work loose from the spindle due
to the braking effect of the motor. Tighten the disc
/ flange securing nut in accordance with the directions
given in the operating instructions. Wait until the disc
comes to a standstill.
DANGER
Check that the speed rating printed on the cutting
or grinding disc is equal to or higher than the rated
speed of the power tool (see accessories).
DANGER
Check the condition of the grinding disc before using
it. Do not use accessories (e.g. discs) that are broken,
cracked or damaged in any way.
en
27