Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3, Turn on the "HOT" and "COLD "water supply and check the water Cold printed
Hot printed
valve and the water supply connections for leaks.
4, Slide your washer into position.
5, Level your washer by turning the leveling legs in or out as
necessary by hand or by using the wrench included with your
washer.
When your washer is level, tighten the locking nuts using the
wrench or (-) flathead screwdriver.
6, Plug the power cord into a 3-Prong, well grounded 120 volt
60 Hz approved electrical outlet protected by a 15-amp fuse
or comparable circuit breaker.
Your washer is grounded through the third prong of the
power cord when plugged into a three-prong grounded
receptacle.
Your washer must be leveled on all four sides. A carpenter's
level should be used on all four corners of your washer. We
recommend you recheck your washer after a dozen or so
washes to make sure it's sitll level.
_
Avoid damage to the legs. Do not move
_
l
the washer unless the Locking-nuts are
fastened to the bottom of the washer.
[_
est run
Make sure that you install your washing machine correctly by running the Rinse+Spin
cycle
after the installation is complete.
STEP 4
Calibration
mode
Your Samsung washing machine automatically detects the weight of the laundry.
For more accurate weight detection, please run Calibration Mode after the installation.
To run Calibration Mode, follow these steps:
1. Turn on the washer.
2. Press the Temp button and Delay Start button simultaneously for at least 3 seconds.
3, Remove any contents in the tub and close the door.
4, Press the Start/Pause
button.
5. The drum rotates clockwise and counterclockwise for approximately 3 minutes.
6, When Calibration Mode is finished, the "En/End" appears on the display and the washing
machine turns off automatically. The washing machine is now ready for use.
hstal in9 your washer 19
\VF395BTPA 03145B I)6 EN indd
19
2014-2 24 ] 1:52:37
Tabla de contenido
