Ottobock 3R78 Instrucciones De Uso página 29

INFORMATION
At a flexion angle > 90°, the compression spring automatically moves the prosthetic knee joint
against the flexion stop. This function is activated in particular when kneeling.
Inform the patient.
►
6.2 Cleaning
CAUTION
Use of unsuitable cleaning agents or disinfectants
Impairment of functionality and damage due to incorrect cleaning agents or disinfectants
► Only clean the product with the approved cleaning agents.
► Only disinfect the product with the approved disinfectants.
► Observe the instructions for cleaning and care.
INFORMATION
► Clean the product if it gets dirty.
► For disinfection, only use disinfectants that do not affect the materials of the product. For
further information, please consult the manufacturer.
Observe the cleaning instructions for all prosthetic components.
►
Cleaning up Minor Dirt
1) Clean the product with a damp, soft cloth.
2) Dry the product with a soft cloth.
3) Allow to air dry in order to remove residual moisture.
Cleaning Heavy Dirt
Required materials: Cleaning cloth, 634A58 Isopropyl Alcohol, soft cloth
>
1) NOTICE! Verify material compatibility! Do not remove lubricant from bearing points!
Clean the product with a cleaning cloth and isopropyl alcohol.
2) Dry the product with a cloth.
Cleaning with Disinfectants
Required materials: colourless, alcohol-free disinfectant (verify material compatibility!), soft
>
cloth
1) Disinfect the product with the disinfectant.
2) Dry the product with a cloth.
3) Allow to air dry in order to remove residual moisture.
7 Maintenance
CAUTION
Failure to follow the maintenance instructions
Risk of injuries due to changes in or loss of functionality and damage to the product
► Observe the following maintenance instructions.
► NOTICE! Do not lubricate and grease the prosthetic joint.
► NOTICE! Repair work must be performed exclusively by manufacturer service.
► Arrange regular maintenance intervals with the patient depending on the level of use.
► Following an individual period for the patient to get accustomed to the prosthesis, check the
settings of the prosthetic joint and adapt them to the patient's requirements again as needed.
► The prosthetic components should be inspected after the first 30 days of use.
► Inspect the entire prosthesis for wear during normal consultations.
29