Operational Cautions; Reactive Force Control - Metabo HPT DH 36DPA Manual De Instrucciones

English
Change lever
Grip
(3) Turn the change lever to
Then bull point or cold chisel is locked.
7. Using depth gauge (Fig. 26)
(1) Loosen the knob on the side handle, and insert the
depth gauge into the mounting hole on the side
handle.
(2) Adjust the depth gauge position according to the
depth of the hole and thighten the knob securely.
Depth gauge
Side handle
8. How to use the drill bit (taper shank) and the taper
shank adapter
(1) Mount the taper shank adapter to the rotary hammer
(Fig. 27).
(2) Mount the drill bit (taper shank) to the taper shank
adapter (Fig. 27).
(3) Turn the switch ON, and drill a hole in prescribed
depth.
(4) To remove the drill bit (taper shank), insert the cotter
into the slot of the taper shank adapter and strike the
head of the cotter with a hammer supporting on the
rests (Fig. 28).
18
Push button
Fig. 24
Fig. 25
mark (Fig. 23).
Mounting hole
Fig. 26
Drill bit
Taper shank adapter
Taper shank adapter

OPERATIONAL CAUTIONS

Resting the unit after continuous work
(1) The power tool is equipped with a temperature
protection circuit to protect the motor.
Continuous work may cause the temperature of the
unit to rise, activating the temperature protection
circuit and automatically stopping operation.
If this happens, allow the power tool to cool before
resuming use.
(2) After use for continuous works, rest the unit for
15 minutes or so when replacing the battery. The
temperature of the motor, switch, etc., will rise if
the work is started again immediately after battery
replacement, eventually resulting in burnout.

REACTIVE FORCE CONTROL

This product is equipped with a Reactive Force Control
(RFC) feature that reduces jerking of the tool body.
If the tool bit is suddenly overburdened, any jerking of the
tool body is reduced by activation of the slip clutch or by
stopping of the motor by the sensor built into the tool body.
If the motor is stopped because of overburdening detection
by the controller, the RFC indicator lamp will blink while
the switch is pulled. In addition, the lamp will continue
blinking for approximately three seconds after the switch
is released. The motor will remain stopped while the lamp
is blinking. (Fig. 29)
Because the RFC feature may not activate or its
performance may be insuffi cient depending on the
working environment and conditions, be careful not to
suddenly overburden the tool bit while operating.
Grip
Front cap
Fig. 27
Cotter
Rest
Fig. 28