Data Record - Beta 1760/OHM Manual Del Usuario Y Operador

data record (store/recall)
1. store function
In the current testing mode, press STORE button one time, enter the STORE function.
On the left upper corner of LCD is shown NO XXXX, which states the currently stored serial
number. Then, press button PEAKHOLD to change into the initial serial number 0000. (Press
again and it will change back).
On the right upper corner of LCD is shown XXXX, which states how many current storage
numbers are used.
Press the STORE button again, access the recording interval time setup function.
On the left upper display is shown 0000 S, which states the recording interval time; use buttons
+ & - to select the range (from 0 to 255 seconds).
When the recording interval time is 0000 s, press the STORE button again to switch to manual
recording. Press the STORE button again to record once.
When the recording interval time selected is 1~255 S, push the STORE button again to start
recording automatically from 0000.
Recording times are shown on the left upper corner, data is shown on the right upper corner
(Due to digitally limitation, only the last four previously stored numbers can be displayed)
82