Yamaha EDL13000TE Manual Del Propietário página 100

EDL20000TE, EDL26000TE
2. Remove dirty engine oil, fill with
new oil and run the engine for
about 5 minutes to let the oil
penetrate to all parts of the en-
gine.
3. Check all the bolts and nuts,
and tighten if necessary.
4. Remove the battery from the
700-100a
engine, adjust the electrolyte
level, and recharge it. Store the
battery in a dark, dry place.
5. When the engine is not used for
a long period of time, run it for
about 5 minutes under no load
every 2 - 3 months to keep it
free from rust. If the engine is
stored without being run, mois-
ture in the air may condense
into dew over the sliding parts
of the engine, resulting in rust.
6. If you forget to run the engine
for longer than 5 - 6 months,
apply enough engine oil to the
valve guide and valve stem seal
and make sure the valve works
smoothly before starting the
engine.
– 91 –
2. 排出全部脏的机油， 注入新油后让
发动机运转约 5 分钟，使机油渗进
发动机的所有部件。
3. 检查所有螺钉和螺母，把松的拧
紧。
4. 从发动机取出蓄电池， 调节电解液
容量并进行充电。 然后把蓄电池保
管在黑暗干燥的地方。
5. 发动机长时间未使用时，应每隔 2
至3个月便无负荷地运转约5分钟，
以不使其积尘。 如果在保管过程中
不进行运转， 空气中的水汽便会在
发动机的滑动部位凝结为水滴， 使
灰尘积蓄下来。
6. 如果您忘记运转发动机超过 5 至 6
个月， 则应在阀门杆及阀门封上加
上足够的机油， 并在启动发动机之
前确认阀门能正常地工作。