Tabla de contenido
Troubleshooting
Problem: The machine doesn't stop feeding the tape.
Possible Cause:
1. Is the count switch plugged in?
2. There may be problems with the measuring wheel
assembly or the computer board.
3. Is the shift rod returning to the cut off and neutral
position?
Problem: The tape dispenser is not measuring the tape correctly.
Possible Cause:
1. Is the tape consistently the wrong length?
2. Is the shift shaft sticking?
3. The clutches may be worn. The solenoid may be faulty.
Problem: The tape is cut, but the cutter blades don't return to the neutral position.
Possible Cause:
1. Are the cutter blades clean?
2. Is the cutter pressure (overlap) set correctly?
Problem: The machine will not feed the tape.
Possible Cause:
1. If the solenoid engages, and the gears will not match up.
Solution:
1. Plug in the count switch. REPAIRS SHOULD ONLY BE
PERFORMED BY QUALIFIED SERVICE PEOPLE.
2. You may need to replace the measuring wheel components
or replace the computer board. REPAIRS SHOULD
ONLY BE PERFORMED BY QUALIFIED SERVICE
PEOPLE.
3. REPAIRS SHOULD ONLY BE PERFORMED BY
QUALIFIED SERVICE PEOPLE.
Solution:
1. REPAIRS SHOULD ONLY BE PERFORMED BY
QUALIFIED SERVICE PEOPLE.
If the tape is not consistently the wrong length, some of
the tape dispenser parts may be worn from usage.
2. REPAIRS SHOULD ONLY BE PERFORMED BY
QUALIFIED SERVICE PEOPLE.
3. REPAIRS SHOULD ONLY BE PERFORMED BY
QUALIFIED SERVICE PEOPLE.
Solution:
1. Clean the cutter (see the Maintenance section).
2. Adjust the bushing inside the gear cover (see the
Maintenance section).
Solution:
1. Remove the keypad and gear cover. Realign the two gears
on the shift shaft. Reinstall the gear cover and keypad.
39
Tabla de contenido
