Overheating Protection - Clatronic FR 3254 Instrucciones De Servicio

Freidora de zonas frías
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 14
2. Fats and oils must be heatable to high temperatures. Do not
use margarine, olive oil or butter: they are not fi t for frying,
because they start to smoke already at low temperatures.
We recommend the use of liquid frying oil.
WARNING:
Please note this important information if you intend
to use fat!
If you use fat, please divide it up into small pieces. Turn
the thermostat to a low temperature and add the pieces
slowly. Once the fat has melted and the correct oil level
is reached you can set the desired temperature on the
thermostat.
Under no circumstances should you place the fat in
the deep frying basket!
3. In order to reduce the acrylamide content of food containing
starch (potatoes, cereals) the temperature during deep-fat
frying should not exceed 170° C (or possibly 175° C). Fur-
thermore, the frying time should be kept as short as possible
and the food only fried until it turns golden yellow.
4. Please note that the safety switch (4) is operated when the
control element is inserted into the guide mechanism.
5. Choose the right frying temperature and check the condi-
tions of the food to be fried. A rule of thumb is that pre-fried
foods require a higher temperature than raw foods.
6. Do not carry or move the deep fryer if the oil or grease is still hot.
7. When frying dough-like foods scrape off the excess dough
and put the pieces carefully into the oil.
8. Please ensure that the handle of the deep fat frying basket
has been correctly attached.
Press the ends of the wire together at the free end of the
handle.
Insert the brackets into wire hoops inside the basket.
The deep fat frying basket must not be more than 2/3
full. Do not overfi ll the frying basket.
9. Rub dry humid foods with a cloth before frying.
CAUTION:
In the case of foodstuffs which are too moist (e.g. frozen
chips etc.) large amounts of foam may form, which under
certain circumstances may cause the oil to overfl ow.
1. Make sure that the appliance is unplugged and switched off
(The control lamps are off.).
2. Take the lid off the deep fryer.
3. Remove the frying basket and fi ll the container with oil or
grease (maximum 3 l). The fi lling level must be located
between the minimum and the maximum level.
4. Insert the plug into a 230 V, 50 Hz power socket. The red
control lamp lights up. Set the desired temperature by
turning the temperature control (3).
5. The green control lamp lights up. Once the set temperature
has been reached the green control lamp goes off. Place
the frying basket containing the items to be fried carefully
into the hot fat.
26
05-FR 3254.indd 26
05-FR 3254.indd 26
Use
6. The green control lamp switches on and off several times
during frying. This is normal and it indicates that the
temperature is controlled by the thermostat and is being
maintained. Once the frying time is over (the frying times are
to be found on the packaging of the food or in the recipe),
please take out the frying basket.
7. Let the oil drip from the food being fried.
8. In order to switch off the machine, please turn the tempera-
ture regulator to MIN and remove the plug from the socket.
Wind the mains lead up in the form of a spiral in the cable
compartment.
Cleaning
1. Make sure that the plug is pulled out.
2. Wait until the deep fryer is completely cool before cleaning.
Wait in any case for 1 to 2 hours after use before using
again to avoid burns.
3. In order to change the oil, pull out the deep frying fat contai-
ner and pour the oil out at the side.
4. Please do not immerse the device in water.
5. Clean the deep frying fat container, the lid and the housing
with a damp clothand household detergent if necessary.
Please do not immerse in water.
6. The deep frying basket can be cleaned in the usual way in
soapy water.
7. Avoid using abrasive materials or sharp objects. These may
damage the deep fryer!
Troubleshooting
Device is not working
Troubleshooting:
Check the mains connection.
Check the position of the thermostat.
Other possible causes:
The device is fi tted with a safety switch (4).
This prevents the heater being switched on accidentally.
Troubleshooting:
Check that the control element is correctly in place.

Overheating Protection

If you should accidentally switch on your deep fat fryer
when there is no oil or fat in it the overheating protection is
automatically turned on. The appliance is no longer ready to
be used. Unplug the deep fryer.
Only after the device has been left to cool down completely
should the „RESTART" button (5) on the rear of the control
element be operated in order to use the deep fat fryer again.
For this you should use a plastic or wooden object that is the
least 4 cm long.
30.06.2008 11:56:46 Uhr
30.06.2008 11:56:46 Uhr
Tabla de contenido
loading

Tabla de contenido