Prepare Measurement; Measuring Blood Pressure; Positioning Cuff - Beurer BC 16 Manual De Instrucciones

4. Prepare measurement

Inserting battery
Remove the battery compartment cover.
Insert the two batteries into the battery compartment
ensuring correct polarity.
Use exclusively brand-name batteries of the type 2 x 1.5 V
Micro (Alkaline Type LR03).
Then close the battery compartment by fitting the cover
and clicking it in position.
If the battery change
urement is no longer possible and you must replace all the bat-
teries. Once batteries have been removed from the device, the
time must be reset. The stored measured values are last.
Used batteries do not belong in the household waste. You are
legally obliged to dispose of the batteries. Dispose of them
via your specialist electrical supplier or local collec ting point
for recyclable waste.
Note: Batteries containing pollutant substances
are marked as follows: Pb = Battery contains
lead, Cd = Battery contains cadmium,
Hg = Battery contains mercury.
Setting date and time
It is vital to set date and time. Only in this way is it possi-
ble to save and subsequently retrieve your measured values
with the right date and time.
is continuously illuminated, meas-
Press the key and
and in turn to adjust the date, hour, minute and con-
firm the entry .
The time is being displayed in 12-hour format, which means
a time from 13:00 onwards is being displayed as pm 1:00.

5. Measuring blood pressure

Positioning cuff

Bare your left wrist, making sure that the circulation in the
arm is not restricted by any clothes etc. that are too tight.
Position the cuff on the inside of your wrist.
Fasten the cuff with the Velcro fastening so that the upper
edge of the monitor is positioned approx. 1 cm below the
ball of your thumb.
The cuff has to be fitted tightly around the wristbut should
not constrict it.
Important: The instrument should only be operated with the
original cuff.
to adjust the month. Then press the