Accessories - Waeco MagicSpeed MS700 Instrucciones De Montaje Y De Uso

MS-700.qxd 24/06/03 15:19 Page 65
Troubleshooting
The engine speed cannot be modified in the diagnostic mode B.
Perform all other tests in the diagnostic mode again to ensure
that the problem does not arise from the electrical connections of the control unit of the
cruise control. Switch off the ignition and leave the diagnostic mode. Leave the ignition
switched off for a few seconds, then press the SET button and restart the vehicle with the
SET button pressed to reach the diagnosticmode.
Repeat test B again. Check the plug connection to the actuator, making sure that the
cables are correctly seated and the colour coding of the plug is correct.
Press the SET or RES button in the diagnostic mode B. You should be able to hear the
electric motor working in the servo unit after pressing the SET or RES button.
If cruise control reacts too erratically in normal operation and the driving speed changes
during normal operation, the GAIN value must be decreased. If cruise control operates
too slowly in normal operation, the GAIN value must be increased.

Accessories

Magnet sensor kit AS71430
The magnet sensor kit is used to generate a cruise signal. There are numerous assembly
possibilities available. The magnets are attached with double-sided adhesive tape to the
cardan shaft or drive shaft. Use the supplied cable clips for the final fastening of the
magnets.
65