Attaching The Cosmetic Cover; Finishing The Prosthesis; Information For Use - Ottobock 3R67 Instrucciones De Uso

7.5 Attaching the cosmetic cover

CAUTION
Use of highly hygroscopic particles (grease-absorbent substances such as talcum)
Risk of injury, damage to the product due to lack of lubrication
Do not allow the product to come into contact with highly hygroscopic particles.
►
► Note the following points for attaching the cosmetic cover:
• Adapt the cosmetic cover to the patient and mount it on the prosthesis.
• Check the settings from the dynamic trial fitting.
► To reduce friction and to eliminate noise, apply 519L5 Silicone Spray directly onto the contact
surfaces of the cosmetic foam cover.

7.6 Finishing the prosthesis

► CAUTION! To avoid a risk of falling, replace set screws that are too short with longer ones.
► Replace set screws that are too long and can cause product damage (for instance through
collision or friction) with shorter ones.
► Before the patient leaves the fitting area, finish the prosthesis by tightening all screw connec­
tions. In doing so, note the instructions for use for all prosthetic components regarding install­
ation torque values and thread lock.
8 Use

8.1 Information for use

NOTICE
Mechanical overload
Impaired functionality due to mechanical damage
► Check the product for damage prior to each use.
Do not use the product if its functionality has been impaired.
►
► Take any necessary measures (e.g. repair, replacement, inspection by the manufacturer's
customer service, etc.).
8.2 Cleaning
CAUTION
Use of unsuitable cleaning agents or disinfectants
Impairment of functionality and damage due to incorrect cleaning agents or disinfectants
► Clean the product only according to the instructions given in this section.
► For the prosthesis, observe the cleaning instructions for all prosthetic components.
Cleaning light soiling
1) Clean the product with a damp, soft cloth.
2) Dry the product with a soft cloth.
3) Allow to air dry in order to remove residual moisture.
Cleaning heavier soiling
Required materials: cleaning cloth, 634A58 isopropyl alcohol, soft cloth
>
► NOTICE! Verify material compatibility. Do not remove lubricant from bearing points.
► Clean the product with a cleaning cloth and isopropyl alcohol.
► Dry the product with a cloth.
25