Hitachi Koki CL 10SA Instrucciones De Manejo página 8

English
NOTE
During normal use or during storage, store the hook
in the latch found on the bottom of the main unit.
6. Using the trimmer
NOTE: Use a special trimmer that is suitable for the
size of the stud.
If it is difficult for the nut to enter the cutting
position, either use a wrench to firmly tighten the
nut or use the accessory trimmer to remove the
flange on the screw thread.
Insert the stud in the hole on the grip. Use a pliers
to retain the stud and rotate the trimmer 5 or 6
times to the right to remove the flange and then
rotate in the opposite direction to remove the
trimmer (Fig. 10).
Pliers Stud
CAUTION
This trimmer is specially designed for Studs Cutter.
The flange on studs cut with a hacksaw or disc
grinder is too large for this trimmer so that the
trimmer does not rotate and it is not possible to
remove flange.
CUTTER LIFE AND REPLACEMENT
1. Cutter life
As is shown in Fig. 11, repeated cutting can cause
breaking and warping of the cutter edge. Using the
cutter in this condition can produce flange on the
cutting location of the studs so that the threads are
distorted. This will prevent clean cuts and make it
impossible to insert the nut.
Breaking
7
Hook
Latch
Fig. 9
Grip
Entrance
Fig. 10
Warping
Fig. 11
As is shown in Fig. 12, the edge is found on four
locations on the cutter. Use the method described
below to change the attachment direction of the
cutter to allow a total of four usages.
If the nut does not fit on the screw due to breaking
and warping of the edge, change the cutter
attachment direction to use the edge without
breaking and warping or replace with a new cutter.
Four edges
on the cutter
2. Changing the cutter attachment direction or replacing
the cutter
(1) Before removing:
1 Pull the trigger switch lightly to slowly operate
bracket (A) and set the cutter in an open condition.
2 Next, make absolutely certain that you turn off the
switch and unplug the power cord from the outlet.
(2) Removal
WARNING!
To prevent accidents, always be sure to turn the
switch OFF and unplug the power cord from the
receptacle.
Use the accessory hexagonal bar wrench to remove
the hex. socket hd. bolt. It is now possible to remove
the cutter and spacer.
Cutter
Bracket (A)
Hex. bar
wrench
(3) Before attaching
1 There are four edges on the cutter. As shown in
Fig. 14, by changing the position of the edge it is
possible to use the blade four times.
( ) (
Turning to
Turning to
the back side
the back side
1st time 2nd time
Fig. 12
Bracket (B)
Hex. socket hd. bolt
Fig. 13
( )(
)
Re-
Turning to
insertion the back side
3rd time 4th time
Fig. 14
)