Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Assembly
Section
3
ASSEMBLY
Your generator requires attachment of the negative battery
cable and is ready for use after it has been properly
serviced with the recommended oil and fuel.
If you have any problems with the assembly of your
generator, please call the generator helpline at
1-888-611-6708.
Remove Generator From Carton
1.
Set carton on a rigid flat surface with "This Side Up"
arrows pointing upward.
2.
Carefully open top flaps of shipping carton.
3.
Cut down corners of carton from top to bottom and
lay that side of carton down flat.
4.
Remove all packing material, carton fillers, etc.
5.
Roll generator out of shipping carton.
Attach Negative Battery Cable
The sealed battery on the generator is fully charged and
pre–installed except for the negative (black) battery cable.
You will need a 1/2" or 13 mm wrench to install the
negative battery cable.
To install:
1.
Cut off tie wrap securing loose end of negative (black)
cable.
2.
Attach negative battery cable with 5/16" x 3/4" screw
and lock washer to the engine block, next to the
starter (Figure 1).Tighten securely.
Figure 1 — Negative Battery Connection
Screw
Positive
battery
cable
Negative
battery
cable
6
Washer
Capítulos
Tabla de contenido
