Installation; Power Supply; Operation Using The External Dc Charger; Operation Using The Battery - Promax TV EXPLORER HD ATSC Manual De Instrucciones

USER'S MANUAL. TV EXPLORER

3 INSTALLATION

3.1

Power Supply

The TV EXPLORER
Li-Ion battery. There is also an external DC charger provided for mains connection and
battery charging.

3.1.1 Operation using the External DC Charger

Connect the
TV EXPLORER HD ATSC side panel. Connect the DC charger to the mains. Then,
press the rotary selector
operation and the battery is slowly charged. When the instrument is connected to the
mains, the CHARGER indicator [4] remains lit. This indicator changes of colour
according to the battery charge status:
RED
ORANGE
GREEN
Table 1.- Indication of the battery charge status (CHARGER).

3.1.2 Operation using the Battery

For the device to operate on the battery, disconnect the power cable and press the
rotary selector [1] for more than two seconds. The fully charged battery can power
the equipment for more than 4.5 hours non-stop.
If battery is very weak, the battery cut-off circuit will prevent the device from
functioning. In such a situation battery must be recharged immediately.
Before taking any measurements, you have to check the charge status of the
battery by checking the battery charge level indicator that appears when activating the
measurement mode pressing key
12/2010
HD ATSC
HD ATSC is a portable instrument powered by one 7.2 V
external DC charger
[1] for more than two seconds. The level meter is now in
BATTERY CHARGE STATUS
OFF
< 50 %
> 50 %
100 %
[12]. These are the indicators on screen:
to EXT. SUPPLY
ON
< 90 %
> 90 %
100 %
[32] on the
Page 13