Cleaning Or Replacing The Air Filter; Cleaning Or Replacing The Petrol Filter; Changing Or Inspecting The Spark Plug; Inspecting The Spark Plug - IKRA IBHS 62 Instrucciones De Manejo

1. Allow the motor to warm up for 3–5 minutes (low
speeds!).
2. Turn the adjustment screw (C):
Clockwise idling speed is increased (+) Anticlockwise
idling speed is reduced (–)
Contact the manufacturer if the cutter continues
running despite being at idling speed.
In such a case, do not continue to work with the
hedge trimmer!

Cleaning or replacing the air filter

Clean the air filter regularly of dust and dirt, in order to
prevent:
- loss of performance
- difficulties starting the tool
- excessive fuel consumption.
21
Clean the air filter about every 8 operating hours, or even
more often in particularly dusty conditions.
1. Set the start lever (choke) (21) to
gets into the carburettor.
2. Remove the air filter cover (19).
3. Remove the air filter (22) from the foam.
4. Wash out the air filter in lukewarm, soapy water.
Do not blow out the dirt, there is a risk of injuries
to the eyes!
5. Clean inside the air filter with a paintbrush.
6. Allow the air filter to dry out properly and reinsert it.
7. Refit the air filter cover.
Change the air filter regularly.
If the air filter is damaged, it must be replaced be-
fore starting work.
GB | Operating instructions

Cleaning or replacing the petrol filter

Check the petrol filter (9) as necessary. A dirty petrol filter
hinders the supply of fuel.
Open the petrol cap (10) and pull the petrol filter through
the opening with a wire hook.
- Light dirt - pull out the petrol filter from the fuel line and
C
- Heavy dirt - replace the petrol filter

Changing or inspecting the spark plug

Do not touch the spark plug (18) or the spark plug con-
nector (17) while the motor is running. High voltage! Risk
of burning when the motor is hot. Wear protective gloves!
Check the spark plug and the separation of the elec-
trodes regularly. To do so, proceed as follows:
1. Pull the spark plug connector out of the spark plug.
2. Unscrew the spark plug with the supplied spark plug
22
The separation between the electrodes should be be-
tween 0.6 and 0.7 mm.
Clean the spark plug if it is dirty.
Replace the spark plug:

Inspecting the spark plug

so that no dirt
1. Pull the spark plug connector out of the spark plug.
2. Unscrew the spark plug with the supplied spark plug
3. Firmly attach the spark plug connector.
4. Push the spark plug against the motor housing with
5. Move the ON/OFF switch to the „START" position.
6. Sharply pull the start cord on the starter handle.
If it is working properly, a spark should be visible between
the electrodes.
11
clean the filter in naphtha
Allen key.
- if the insulating body is damaged
- if there is significant loss of material on the electrodes
- if the electrodes become very dirty or heavily soiled
with oil
- each month if the tool is used regularly
Allen key.
isolated pliers (not in the vicinity of the spark plug
hole).