Unpacking The Appliance; Overview Of The Components - Clatronic KA 3733 Manual De Instrucciones

Unpacking the Appliance

1. Remove the appliance from its packaging.
2. Remove all packaging material such as plastic films, filler
material, cable ties and cardboard packaging.
3. Sensitive surfaces are possibly protected with foil.
Remove these foils.
4. Check the content for any missing parts.
5. In the event that the packaging content should be incom-
plete or if damages are noticeable, do not operate the
appliance. Return it to the dealer immediately.
NOTE:
There may be dust and production residue on the
appliance. We recommend cleaning the appliance as
described under "Cleaning".

Overview of the Components /

Scope of Delivery
1 Filter holder
2 Permanent filter
3 Tab for opening the water tank lid
4 Water tank lid
5 Water spout
6 Water tank
7 Water level display
- 14 OZ 420 ml
- 10 OZ 300 ml
- 8 OZ 240 ml
8 Basic appliance
9 button
10 Storage surface
11 Thermo stainless steel cup
Notes for Use
Placement
• Place the automatic coffee maker on a stable and level
surface. Place the appliance in such way that it cannot
tip over.
• Do not place the appliance in close proximity to a gas or
electric stove or any other heat source.
Note About the Brewing Process
During the brewing process and depending on the degree of
grinding and the used amount, the coffee powder absorbs
a certain amount of water. That is why the quantity of coffee
might diverge from the quantity of water in the water tank.
32
KA3733_IM
European Regulations on Energy Saving
NOTE:
The European Directive 2009 / 125 / EC (Ecodesign Direc-
tive) incorporates measurements for energy saving.
The following applies to coffee makers: For coffee
machines that store the coffee in an isolated container
a maximum waiting time of 5 minutes applies at the end
of the last brewing cycle. The appliance switches off
automatically.
You benefit from better safety and lower energy con-
sumption.
Electric Connection
1. Ensure that your mains power corresponds with the
specifications of the appliance. The specifications are
printed on the type label.
2. Connect the mains cable to a properly installed and
earthed wall outlet.
Initial Operation
Operate the appliance 2 times with clean water before
brewing coffee for the first time. This removes dust, which
may have collected during transport. Follow the instructions
given under "Operation".
Turning the Appliance On / Off
• Press the button to switch on the appliance. The indica-
tor lamp of the button lights up.
• Press the button again to turn off the appliance or to can-
cel brewing. The indicator lamp of the button turns off.
Operation
1. Open the lid of the water tank.
2. Fill the water tank with cold water.
CAUTION:
Do not overfill the tank! Do not fill it above the 14 OZ
420 ml mark.
3. Insert both the filter holder and the permanent filter.
4. Fill coffee powder into the permanent filter.
NOTE:
Do not put too much coffee powder into the filter to
avoid spillage.
5. Now close the lid of the water tank. It must engage.
6. Place the thermo stainless steel cup without lid on the
storage surface.
NOTE:
Hold the thermo stainless steel cup slightly tilted.
7. Switch on the appliance. The indicator lamp of the button
lights up.
05.03.19