Design Of The Spray Gun; Intended Use; General Safety Instructions - SATA minijet 4400 B Instrucciones De Servicio

Operating instructions SATAminijet 4400 B RP/HVLP
4.

Design of the Spray Gun [1]

[1-1] Spray gun handle
[1-2] Trigger
[1-3] Nozzle set consisting of air
cap, fluid tip (not visible),
paint needle (not visible)
[1-4] Spray gun connection with
QCC
[1-5] Gravity flow cup connection
with QCC
[1-6] Paint strainer (not visible)
[1-7] Gravity flow cup
[1-8] Gravity flow cup lid
5.

Intended Use

The spray gun has been designed for the application of paints, lacquers
and other sprayable media by means of compressed air on suitable sub-
strates and surfaces.
6. Safety Instructions

6.1. General safety instructions

• Before using the spray gun, please read all safety and the operating
instructions carefully. Safety instructions and indicated safety meas-
ures are mandatory.
• Please keep all enclosed documents and make sure that the spray
gun is handed over only together with these documents.
6.2. Specific safety instructions for spray guns
• Local safety, accident prevention, work and environment protection
regulations are mandatory!
[1-9] Anti-drip device
[1-10] Round/flat spray control
[1-11] Material flow control screw
[1-12] Material flow control counter
[1-13] Air micrometer (air flow
[1-14] Air micrometer (air flow con-
[1-15] Air piston (not visible)
[1-16] Compressed air connection
[1-17] ColorCode-System (CCS)
Warning! Attention!
Warning! Attention!
nut
control knob)
trol) locking screw
EN
103