RIDGID R4031 Manual Del Operador página 23

OPERATION
TO MAKE A MITER CUT
See Figure 31.
Miter cuts are used for cutting outside and inside corners
on material, decorative chair rail, and base molding with
the material at any angle to the wheel other than 90°. Miter
cuts tend to "creep" during cutting. This can be controlled
by holding the workpiece securely against the miter guide.
 F ill the water reservoir with clean tap water.
 Using a straight edge or square, draw a line on the tile
with a marker or grease pencil.
 Install the miter guide to the left of the wheel.
 Set the miter guide to desired angle using the miter guide
scale, and tighten securely with lock knob.
 Make sure miter guide is not in the cut path.
 Place the material on the table and firmly against the
sliding table fence.
 Make sure the material is clear of the cutting wheel before
turning on the saw.
 Turn the on/off switch to the ON position.
 Let the cutting wheel build up to full speed and wait for
the wheel to get wet before moving the material into the
wheel.
 Hold the material firmly against the sliding table fence
and feed the material into the cutting wheel.
 When the cut is made, turn the saw OFF. Wait for the
cutting wheel to come to a complete stop before removing
any part of the material.
TO MAKE AN L-CUT
See Figure 32.
L-cuts are cuts that remove a piece of tile to fit in a corner,
around a cabinet, or a piece of molding and are made by
two separate cuts.
NOTE: Only overcut on the bottom or under side of the
material being cut.
 F ill the water reservoir with clean tap water.
 Using a straight edge or square, draw a line on the tile
with a marker or grease pencil.
 Remove the miter guide.
 Place the material on the table and firmly against the
sliding table fence.
 Make sure the material is clear of the cutting wheel before
turning on the saw.
 Turn the on/off switch to the ON position.
 Let the cutting wheel build up to full speed and wait for
the wheel to get wet before moving the material into the
wheel.
 Hold the material firmly against the sliding table fence
and feed the material into the cutting wheel.
 Make the cut far enough into the material without
overcutting.
 When the cut is made, turn the saw OFF. Wait for the
cutting wheel to come to a complete stop before removing
any part of the material.
 Turn the material over and make the second cut along
one of the marks. This time overcut the other line and the
cut piece should separate from the rest of the material.
 When the second cut is made, turn the saw OFF. Wait
for the cutting wheel to come to a complete stop before
removing any part of the material.
23 — English
MITER CUT
L-CUT
Fig. 31
Fig. 32