Padded Swing-Away Armrests; Swing-In/Swing-Out Hangers And Footrests; M.elevating / Articulating Legrest; N.angle Adjustable Footplates - Sunrise Medical Quickie QXi Manual De Instrucciones

Q XI / Q X
K. PADDED SWING-AWAY ARMRESTS
1. Mounting and Height adjustment
a. swing-away armrests(B) can be detached or can swing away to allow lateral transfers. they are height
adjustable (1" increments) by moving bolt (A) up or down in predrilled holes on armrest bracket.
b. Additional height can be achieved by removing bolts (c) and moving the receiver(D) or the entire
hardware assembly up or down the rear frame tube. Ensure bolts (c) are retightened
(torque to 144 in lbs).
L. SWING-IN/SWING-OUT HANGERS AND FOOTRESTS
1. Height Adjustment
NOTE–it is recommended that you maintain a minimum of 2.0 inches between the lowest point on the
footrest and the floor.
a. loosen set screw (E) using a 3/16 inch hex key.
b. slide footrest extension up or down inside frame tube to desired height.
c. tighten set screw. Use a torque setting of 144 in-lbs (16.27 nm).
M. ELEVATING / ARTICULATING LEGREST (Optional)
1. Height Adjustment (see "Swing-in/Swing -out Hangers" above)
2. ELR Pad height Adjustment
a. to raise or lower the legrest Pad, loosen the nylock nut(g) with a 3/16" wrench and lift or lower
to desired position.
b. once your preferred position is reached, tighten the nut to 60 in-lbs.
N. ANGLE ADJUSTABLE FOOTPLATES
Adjusting the angle on the Footplate
a. loosen the flat head screws (g).
b. Adjust footplate (h) to desired angular position.
c. Re-tighten hardware (g).
120346 Rev. D
19
20
21
22
24
IX. DEALER SERVICE AND ADJUSTMENT
F
19
B
A
D
c
20
21
22
h