Pressure Washer Maintenance - Briggs & Stratton ELITE Serie Manual Del Propietário

GENERAL MAINTENANCE
RECOMMENDATIONS
The pressure washer warranty does not cover items that
have been subjected to operator abuse or negligence.To
receive full value from the warranty, the operator must
maintain the pressure washer as instructed in this manual.
• Some adjustments will need to be made periodically to
properly maintain your pressure washer.
• All maintenance in this manual and the engine owner's
manual should be made at least once each season.
• If equipped with inflatable tires, keep the air pressure at
the value marked on the tire or within 15 and 40 psi.
PRESSURE WASHER
MAINTENANCE
Check In-Line Filter
Refer to Figure 22 and service the in-line filter if it
becomes clogged, as follows:
Figure 22 — Clean In-Line Filter
Nozzle Extension
1. Detach spray gun and nozzle extension from high
pressure hose. Detach nozzle extension from spray
gun and remove o-ring and screen from nozzle
extension. Flush screen, spray gun, and nozzle
extension with clean water to clear debris.
2. If screen is damaged, the o-ring kit contains a
replacement in-line filter screen and an o-ring. If
undamaged, reuse screen.
Pressure Washer
3.
4.
5.
Check and Clean Inlet Screen
Examine the screen on the water inlet. Clean it if the
screen is clogged or replace it if screen is damaged.
Check High Pressure Hose
The high pressure hose can develop leaks from wear,
kinking, or abuse. Inspect the hose each time before using
it. Check for cuts, leaks, abrasions or bulging of cover,
damage or movement of couplings. If any of these
conditions exist, replace the hose immediately.
Check Chemical Injection Hose
Filter Screen
Examine the filter on the detergent tube and clean if
clogged.The tube should fit tightly on the barbed fitting.
O-ring
Examine the tube for leaks or tears. Replace the filter or
tube if either is damaged.
Check Gun and Nozzle Extension
Examine the hose connection to the spray gun and make
sure it is secure.Test the trigger by pressing it and making
sure it "springs back" into place when you release it. Put
the safety latch in the ON position and test the trigger.You
should not be able to press the trigger.
12
Place in-line filter screen into threaded end of nozzle
extension. Direction does not matter. Push the screen
in with eraser end of pencil until it rests flat at bottom
of opening.Take care to not bend screen.
Place o-ring into threaded end of extension. Push
o-ring snugly against in-line filter screen.
Assemble nozzle extension to spray gun, as described
earlier in this manual.
WARNING!
NEVER repair a high pressure hose.
Replace it with another hose that exceeds the
maximum pressure rating of your pressure washer.