Tabla de contenido
Idiomas disponibles
Idiomas disponibles
4.
While still holding the cuttinghead handle (L) Fig. 41
firmly, loosen the cuttinghead clamp knob, and slowly
pull the cuttinghead (D) Fig. 41 toward the front of the
track arm (E) until the travel stops. Turn the switch (H)
"OFF".
5.
Wait for the saw blade (M) Fig. 42 to stop, then return
the cuttinghead (D) to the rear of the track arm (E). Note
the saw kerf (N) Fig. 42 in the table boards.
IMPORTANT: Raise the track arm (E) Fig. 42 before
attempting to rotate it. Perform the procedure "CUTTINg
INTO THE TABLE BOARdS" for each separate angle cut.
If, during operation, the saw has a tendency to tip over, slide, or walk on the supporting surface, secure the
saw to the floor surface through the holes provided on the bottom of each leg.
OPERATIONAL CONTROLS ANd AdJUSTMENTS
Before using the saw, verify the following each and every time:
1.
ALWAYS wear proper eye, hearing, and respiratory equipment.
2.
Blade is tight.
3.
Bevel angle and height lock knobs are tight.
4.
If ripping, ensure fence lock lever is tight and fence is parallel to the blade.
5.
The blade guard is properly attached and the anti-kick teeth are functioning.
6.
ALWAYS inspect the guard and splitter for proper alignment operation and clearance with saw blade.
Failure to adhere to these common safety rules can greatly increase the likelihood of injury.
To reduce the risk of injury, turn unit off and disconnect machine from power source before installing
and removing accessories, before adjusting or changing set-ups, or when making repairs. An accidental
start-up can cause injury.
Before connecting the radial arm saw to the power source or operating the saw, always inspect the
guard and splitter for proper operation alignment and clearance with saw blade. Personal injury may
result.
If your saw makes an unfamiliar noise, or if it vibrates excessively, cease operating immmediately until the
source has been located and the problem corrected.
STARTINg ANd STOPPINg
Make sure that the switch is in the "OFF" position before plugging cord into outlet. do not touch the
plug's metal prongs when unplugging or plugging in the cord.
The on/off switch (A) Fig. 43 is located at the front of the cuttinghead. To turn the saw "ON", move the switch (A) up to the
"ON" position. To turn the saw "OFF", move the switch down to the "OFF" position.
d
d
M
OPERATION
18
E
H
N
L
Fig. 41
E
Fig. 42
Tabla de contenido
