Master/Slave Mode - HQ-Power VDPLP56SL Manual Del Usuario

Stand-Alone Mode
Sound-Active Mode
This mode allows a single unit to run to the beat of the music.
• Press <MENU> until
• Press <ENTER> to confirm your selection.
• Use <UP> or <DOWN> to select the desired program (p5 ~ p6).
• Press <ENTER> to confirm your selection.
• Use the audio sensitivity knob on the back of the fixture to make the fixture more or less sensitive.
The PAR56 will react to the low frequencies of the music via the internal microphone.
Auto Mode
• Press <MENU> until
• Press <ENTER> to confirm your selection.
• Use <UP> or <DOWN> to select the desired program (p1 ~ p4).
• Press <ENTER> to confirm your selection.
Preset Colours
This PAR56 has pre-programmed static colours.
• Press <MENU> until
• Press <ENTER> to confirm your selection.
• Use <UP> or <DOWN> to select the desired program (c1 ~ c7).
• Press <ENTER> to confirm your selection.
Custom Static Colours
This PAR56 allows you to create custom static colours.
• Press <MENU> until
• Press <ENTER> to confirm your selection.
• Use <UP> or <DOWN> to select the desired colour value (000 ~ 100, from 0 to 100%).
• Press <ENTER> to confirm and to move to the next colour (r, g, b). Set the value for the second and
third colour.
• Finally, press <ENTER> to confirm. Note that you will have selected the first colour. Simply press
<MENU> to exit.

Master/Slave Mode

This mode allows control several units simultaneously.
• Use standard DMX cables to daisy-chain your units together via the DMX connector on the rear of
each fixture. For longer cable runs we suggest using a terminator on the last fixture.
• Choose the first unit in the chain to function as the master fixture. Press <MENU> and choose a
mode (p--, c-- or u--).
• Press <ENTER> to confirm your selection.
• On each of the connected slave units, press <MENU> until 3-ch or 7-ch is displayed.
• Press <ENTER> to confirm your selection.
• Use <UP> or <DOWN> to set the DMX starting address to d001.
DMX Mode
This mode allows you to control the fixture by any universal DMX controller.
• Press <MENU> until 3-ch or 7-ch is displayed.
• Press <ENTER> to confirm your selection.
• Use <UP> or <DOWN> to set the DMX starting address.
• Press <ENTER> to confirm your selection.
DMX Channel Values
3-Channel Mode
channel function
1
2
3
23.07.2010
P--
is displayed.
P--
is displayed.
c--
is displayed.
u--
is displayed.
from
red 000
green 000
blue 000
VDPLP56SL
to
255
255
255
6
description
dimmer 0 ~ 100%
dimmer 0 ~ 100%
dimmer 0 ~ 100%
©Velleman nv