Foppapedretti Eureka Manual De Instrucciones página 100

COMPONENTS
1 x Carrycot frame
ASSEMBLING THE FRAME
1. Release both connectors from the elastic locking band and rotate them 90° outwards. A click will indicate
that they have opened correctly.
2. Lift up the handle, a click will indicate that it is locked in the vertical position. Make sure that it is
locked.
3. Press the bottom of the carrycot downwards and at the same time pull the handle upwards to raise the
sides of the carrycot (fig. 3a/b). Unhook the Velcro and lift up the fabric along the side on the inside
(fig. 3c).
4. Pull the frame support brackets towards the outside of the carrycot, using the straps, until they lock into
the 4 clips. Make sure that the brackets are locked into the 4 clips.
5. Fold the fabric on the side towards the inside of the carrycot, attach the Velcro in the lower part along
the inner edge. Make sure that the fabric is properly secured with Velcro and that there are no openings
along the side.
6. Place the mattress inside the carrycot.
ASSEMBLING THE HOOD
Place the hood on the handle, wrap the front fabric of the hood around the handle, attach and close the
zip. Attach the press studs (fig. 7).
ADJUSTING THE HANDLE/HOOD
Press the side buttons and adjust the handle to the new position, release the buttons and make sure that
it is locked (fig. 8).
Ventilation: Open the zip on the back of the hood and lift up one flap or both flaps to increase the
ventilation inside the carrycot (fig. 9).
COVER
Fix the cover along the sides with the press studs (a), attach the flaps with the press studs to the hood (b),
(fig. 10).
Lift up the front fabric flap of the cover for added protection (c), attach the press studs (fig. 11).
The cover has a storage pocket (fig. 12).
• ENGLISH •
ASSEMBLY
1 x Mattress
12
1 x Footmuff