Idiomas disponibles
Idiomas disponibles
1. Fix a screw (not supplied) into the desired wall, leaving the head extended
out the by about 5mm as indicated above.
2. Using the Weather Station's hanging hole, carefully hang it onto the screw
(always ensure product locks onto the screw head before releasing).
Note: Users are recommended to check that the DCF-77 & 433 MHz
signals are receivable before fixing the screw(s) into the wall for
hanging or for permanent wall mounting. Should the Weather
Station not pick up either signal from the desired location, then
relocate in a different place. Once the signals are received, secure
the screw(s).
Important Notes:
•
Avoid placing the units where they can be exposed to sudden changes in
temperature; i.e. direct sunlight, extreme cold and wet/moist conditions.
This will help avoid any inaccurate readings and any possible damage to
the unit.
•
Should the unit be exposed to extreme and sudden temperature changes,
it will lead to rapid changes in its forecast reading and thereby reduce its
accuracy.
•
Should the unit be moved to another location that is significantly higher or
lower than its initial standing point (for example from the ground floor to
the first floor of a house), then either reset the units or discard the readings
weather forecasts for the next 12-24 hours. By doing so, this will allow
more time for an more accurate reading. This will allow sufficient time for
the unit to operate at a constant altitude and thus enabling an more accurate
forecast.
•
At some stage of use, users will experience a different outdoor temperature
reading from the transmitter compared to the Weather Station. This is not
cause for concern or to regard the units as being faulty. The transmitter
and Thermo-station each have an individual clock that reads the
temperature according to its own programmed time interval. The transmitter
updates the temperature every 60 secondes, but the Weather Station
updates the 433 MHz signal from the transmitter twice every 10 minutes.
This means that the transmitter can be displaying a temperature not yet
received by the Weather Station due to the time difference.
GB
P.38
Relative humidity measuring range
Relative air pressure setting range
Sensitivity setting (hPa) for weather
icon switching
Air pressure history
Temperature checking intervals:
Indoor
Transmitter to the Weather Station
reception
Transmitter temperature reading update : 60 seconds
Transmitting frequency
Temperature transmitting range up to
Output transmission power
Power source:
Weather Station
Transmitter
Battery life for both Units
(alkaline batteries recommended)
Dimensions (L x W x H):
Weather Station
Transmitter (excluding holding case)
GB
P.40
: 25% to 90% with 1% resolution
("- - " displayed if outside this
range)
: 970 hPa to 1030 hPa
: 2 hPa to 4 hPa
: for the past 72 hours
(0, -1, -3, -6, -12, -24, -48, -72)
: 10 seconds
: twice in 10 minutes
: 433.92 MHz
: 25 metres
: -3dBm
: 2 x AA, IEC LR6 1.5V batteries
: 2 x AAA, IEC LR3 1.5V batteries
: Approximately 12 months
: 145 x 31 x 412 mm
: 56 x 24 x 80 mm
Maintenance
•
Extreme temperatures, vibration and shock should be avoided as these
may cause damage and inaccurate readings.
•
When cleaning the display and casing, use a soft damp cloth only. Do not
use solvents or scouring agents as they may mark the LCD and casing.
•
Do not submerge the unit in water.
•
Immediately remove all low powered batteries to avoid leakage and
damage. Replace only with new batteries of the recommended size.
•
Do not make or attempt to make any repairs to the unit. Return it to its
original point of purchase for repair by an qualified engineer. Opening and
tampering with the unit may invalidate its guarantee.
Replacing batteries:
For best performance or when the LCD screen contrast becomes dim and
unclear, batteries should be replaced to both units at least once a year to
maintain maximum running accuracy.
Please help in the preservation of the environment and return
used batteries to an authorized depot.
Specification:
DCF-77 Radio controlled time signal
Recommended operating temperatures:
Weather Station
Transmitter
Temperature measuring range
Indoor
Outdoor
Liability Disclaimer
•
The manufacturer and supplier cannot accept any responsibility for any
incorrect readings and any consequences that occur should an inaccurate
reading take place.
•
This product is not to be used for medical purposes or for public information.
•
This product is designed for use in the home as indication of the future
weather and is not 100% accurate. Weather forecasts and barometric
readings given by this product should be taken only as an indication and
not as being totally accurate.
•
The specifications of this product may change without prior notice.
•
This product is not a toy. Keep out of the reach of children.
•
No part of this manual may be reproduced without written consent of the
manufacturer.
R&TTE Directive 1999/5/EC
Abridged edition of Declaration of Conformity in vernacular. We hereby declare
that this wireless transmission device does comply with the essential
requirements of R&TTE Directive 1999/5/EC.
: 77.5 kHz
: 0°C to +50°C
: -30°C to +70°C
: 0°C to +50°C with 0.1°C resolution
("OFL" displayed if outside this
range)
: -29.9°C to +69.9°C with 0.1°C
resolution
("OFL" displayed if outside this
range)
GB
P.39
GB
P.41
