Programming; Programming Button Description; End Limit Setting And Self-Learning; Remote Control Description - SOMFY Dexxo Pro io Serie Manual De Instalación

PROGRAMMING

Programming button description

End limit setting and self-learning

For swinging doors, change the P9 setting before starting self-learning.
[1]. Press the "SET" button until the light comes on (2 s).
The display shows "S2"
[2]. Control the motor using the "+" or "-" buttons so that the transmission system runner moves to link up with the trolley and closes the door.
• Pressing and holding the " -" button closes the door.
Release the "-" button before the motor has time to force against the door.
• Pressing and holding the " +" button opens the door.
[3]. Adjust the closed position using the "+" or "-" buttons.
Release the "-" button before the motor has time to force against the door.
[4]. Press "OK" to validate the closed end limit position and start the self-learning cycle.
The door runs through a complete Open Close cycle.
• If learning was correct, the display will show "
• If the learning cycle was not completed correctly, the display will show "
During the learning cycle:
• If the door is moving, pressing any button will stop the movement and interrupt the learning mode.
• If the door is stopped, pressing "
You can call up the learning mode at any time, even when the learning cycle has already been executed and the display shows "C1".

Remote control description

Individual control buttons
1
General STOP button
2
General CLOSE button (Keytis 4 home io only)
3
Operation indicator light
4
Low battery indicator light
5
Closing clip
6
PROG button: programming the transmitter
7
KEY button: memorising the system key
8

Fitting the battery

Fig.

Programming remote controls

. If the installation already comprises other io-homecontrol® products with at least one programmed remote control then
you must perform the Memorising the system key step before programming the remote controls (Fig. 20).
. If the Keytis io remote control to be programmed is the system's first remote control, then go straight to Programming the Keytis
remote control step (Fig. 21 to 23).
The operations for memorising the system key and to program a remote control by copying another Keytis remote control are
only possible at the installation location. To gain authorisation to transfer its system key or its programming, the previously
programmed remote control must be able to establish radio communication with an installation receiver.
5
Fig. 16
C1".
SET" once will exit the learning mode.
Fig. 17
On Intermittent
18
Fig. 19 to 23
. Press for 2 s: memorise remote controls
. Press for 7 s: delete remote controls
. Press for 0.5 s: call up and exit the setup menu
. Press for 2 s: start learning
. Press for 7 s: clear learning and settings
. Stop learning
. Selecting a setting
. Modifying a setting value
. Using the forced mode
. Start the learning cycle
. Confirm setting selection
. Confirm setting value
S1".
Blinking