Technical Specifications; Dimensions - SOMFY Dexxo Pro io Serie Manual De Instalación

TECHNICAL SPECIFICATIONS

BASIC TECHNICAL CHARACTERISTICS
Mains supply
Max. power consumption
Traction force
Use
Number of Opening/Closing cycles per day
Max. speed
Programming interface
Operating temperature
Travel end limits
Electrical insulation
Built in lighting
Somfy radio frequency
Number of channels that can be memorised
CONNECTIONS
Safety input
Pedestrian door safety input
Wired control input
Remote lighting output
Orange light output
24 V controlled power supply output
Safety input test output
Accessory power supply output
Remote aerial input
Backup battery input
OPERATION
Forced operation mode
Lighting time delay (after movement)
Automatic closing mode
Orange light pre-warning
Safety input operation
Built-in obstacle detection
Operation when an obstacle is detected
Preset partial opening command
Progressive start up
Opening speed
Closing speed
Closure approach speed
Troubleshooting
(1) Maximum load for motor to start and drive door for at least 5 cm (according to RAL-GZ definition)

Dimensions

11
Standby-Operation
Peak force
Starting force (1)
20 cycles max. per day with a standard rail - 50 cycles max. per day with a high performance rail tested
Type
Compatibility
Autonomy
While closing
Before opening
(Dangerous Movement Area Accessible
to the Public)
Overall length: 3,295 / 3,895
Available travel: 2,555 / 3,155
171 min 140
63.6
Fixation: 2,982 / 3,582
Rail: 2,900 / 3,500
Overall length: 3,153 / 3,753
Rail : 2,900 / 3,500
Dexxo Pro 800 io
230 V - 50 Hz
5 W - 600 W (with 500 W remote lighting)
800 N
650 N
for 36,500 cycles with a standard rail and 90,000 cycles with a high performance rail
18 cm/s
7 buttons - 2 character LCD display
- 20 ° C / + 60 ° C - indoor dry - IP 20
Mechanical stopper at opening
Memorized end limit position at closing
Class 2: double insulation
230 V / 40 W ; E14 socket
868 - 870 MHz
Situo io : 6
Dry contact: NC
Photoelectric TX/RX cells - Reflex cell - Sensor strip with dry contact output
Dry contact: NC
Dry contact: NO
230 V - 500 W - class 2
24 V - 15 W with built in flashing control
Yes: for possible photoelectric TX/RX cell self-test
Yes: for possible reflex cell or sensor strip self-test
24 V - 500 mA max
Yes: io aerial compatible (Réf. 9013953)
Yes: battery pack compatible (Réf. 9001001)
12 hours; 1 to 3 cycles depending on door
Charge time: 48 hours
By pressing and holding the motor control button
Programmable : 60 s to 600 s
Yes: programmable closing time delay from 10 to 120 s
Programmable: with or without prior warning (duration set to 2 s)
Programmable: Stop - Partial re-opening - Full reopening
Programmable: no effect or motion refused
Adjustable sensitivity: 4 levels
Programmable : partial re-opening or full reopening
Yes can be selected: adjustable partial opening position
Programmable from 3.5 cm/s to 18 cm/s: 10 possible values
Programmable from 3.5 cm/s to 18 cm/s: 10 possible values
Programmable: does not slow down, short slowdown zone (30 cm),
long slowdown zone (50 cm)
Recording and accessing data: Cycle counter, cycle counter with obstacle detection, number of radio
channels stored, history of the last ten defects recorded.
313.6
254.1
404.2
112.2
224.4
Dexxo Pro 1000 io
1000 N
800 N
Others: unlimited
Yes