Additional Safety Warnings - Dremel 9100 Instrucciones De Funcionamiento

DM 2610Z04970 10-13_9100 10/9/13 7:52 AM Page 5
grabs, the wheel itself usually breaks. When
the steel saw, high speed cutters or tungsten
carbide cutter grab, it may jump from the
groove and you could lose control of the tool.
Use only Dremel
accessories. Other accessories are not
designed for this tool and may lead to personal
injury or property damage.
After changing bits or making any
adjustments, make sure the bit is properly
secured by pulling the EZ Change™ levers
forward. Loose adjustment devices can
GFCI and personal protection devices like
electrician's rubber gloves and footwear will
further enhance your personal safety.
Do not use AC only rated tools with a DC
power supply. While the tool may appear to
work, the electrical components of the AC
rated tool are likely to fail and create a hazard
to the operator.
Keep handles dry, clean and free from oil
and grease. Slippery hands cannot safely
control the power tool.
Use clamps or other practical way to secure
and support the workpiece to a stable
platform. Holding the work by hand or against
your body is unstable and may lead to loss of
control.
Develop a periodic maintenance schedule
for your tool. When cleaning a tool be
careful not to disassemble any portion of
the tool since internal wires may be
misplaced or pinched or safety guard return
springs may be improperly mounted.
Certain cleaning agents such as gasoline,
Safety Rules for Rotary Tools - (cont.)
®
, high-performance

Additional Safety Warnings

unexpectedly shift, causing loss of control,
loose rotating components may be ejected.
Do not plug the motor unit directly into
wall outlet. Always plug the motor unit into
the output connector of the Variable Speed
Foot Pedal. Operating accessory beyond its
speed rating will cause severe injury
Do not use the tool if the Variable Speed
Foot Pedal or the "ON/OFF" switch is not
functioning normally.
DO NOT OPERATE WITH ROUTER BITS.
Serious personal injury will occur.
carbon tetrachloride, ammonia, etc. may
damage plastic parts.
Risk of injury to user. The power cord must only
be serviced by a Dremel Service Facility..
Some dust created by power
W RNING
sanding, sawing, grinding,
drilling, and other construction activities
contains chemicals known to cause cancer,
birth defects or other reproductive harm.
Some examples of these chemicals are:
• Lead from lead-based paints,
• Crystalline silica from bricks and cement and
other masonry products, and
• Arsenic and chromium from chemically-
treated lumber.
Your risk from these exposures varies,
depending on how often you do this type of
work. To reduce your exposure to these
chemicals: work in a well ventilated area, and
work with approved safety equipment, such as
those dust masks that are specially designed
to filter out microscopic particles.
5