Tire Pressure; To Remove The Jumper Cables; To Remove The Mulch Plug; To Examine The Blades - Jonsered FR 2312 MA Manual De Usuario

Ocultar thumbs Ver también para FR 2312 MA:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

3. Connect one end of the red cable to the POSITIVE
battery terminal (+) on the weak battery (A).
B
A
4. Connect the other end of the red cable to the
POSITIVE battery terminal (+) on the fully charged
battery (B).
WARNING: Do not short circuit the ends
of the red cable against the chassis.
5. Connect one end of the black cable to the
NEGATIVE battery terminal (-) on the fully charged
battery (C).
6. Connect the other end of the black cable to a
CHASSIS GROUND (D), away from the fuel tank
and the battery.
7. Replace the covers.

To remove the jumper cables

Note: Remove the jumper cables in the opposite
sequence to how you connect them.
1. Remove the BLACK cable from the chassis.
2. Remove the BLACK cable from the fully charged
battery.
3. Remove the RED cable from the 2 batteries.
22
C
D

Tire pressure

The correct tire pressure is 60 kPa (0.6 bar / 8.5 PSI) on
all 4 tires.

To remove the mulch plug

You find the mulch plug on the bottom side of the cutting
deck.
1. Remove the cutting deck, see
deck on page 11 .
2. Remove the screw that holds the mulch plug and
remove the mulch plug.
3. Put the cutting deck in mow position.
4. Attach the mulch plug in the opposite sequence.

To examine the blades

CAUTION: Damaged or incorrectly balanced
blades can cause damage to the product.
Replace damaged blades. Let an approved
service agent help you sharpen and balance
blunt blades.
1. Remove the cutting deck, see
deck on page 11 .
To remove the cutting
To remove the cutting
828 - 001 -
Tabla de contenido
loading

Este manual también es adecuado para:

Fr 2312 m

Tabla de contenido